Hi it depends on your architecture, do you have to bind an interface to a single VM?
Alfredo > On 07 Jul 2015, at 14:50, C. L. Martinez <[email protected]> wrote: > > Hi all, > > I need to use pf_ring to setup some virtual IDS host sensors in > CentOS 6.x/7.x KVM hosts. > > With PF_RING recent releases, do I need to install it in both (kvm > host and kvm guests) or only in kvm guest?? > > These kvm hosts have broadcom interfaces: > > tg3.c:v3.137 (May 11, 2014) > tg3 0000:03:04.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 > tg3 0000:03:04.0: eth1: Tigon3 [partno(011276-001) rev 9003] > (PCIX:133MHz:64-bit) MAC address 80:c1:6e:62:f4:44 > tg3 0000:03:04.0: eth1: attached PHY is 5714 (10/100/1000Base-T > Ethernet) (WireSpeed[1], EEE[0]) > tg3 0000:03:04.0: eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] > tg3 0000:03:04.0: eth1: dma_rwctrl[76148000] dma_mask[40-bit] > tg3 0000:03:04.1: PCI INT B -> GSI 17 (level, low) -> IRQ 17 > tg3 0000:03:04.1: eth2: Tigon3 [partno(011276-001) rev 9003] > (PCIX:133MHz:64-bit) MAC address 80:c1:6e:62:f4:45 > tg3 0000:03:04.1: eth2: attached PHY is 5714 (10/100/1000Base-T > Ethernet) (WireSpeed[1], EEE[0]) > tg3 0000:03:04.1: eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] > tg3 0000:03:04.1: eth2: dma_rwctrl[76148000] dma_mask[40-bit] > tg3 0000:03:04.1: irq 61 for MSI/MSI-X > tg3 0000:03:04.1: eth1: Link is up at 1000 Mbps, full duplex > tg3 0000:03:04.1: eth1: Flow control is on for TX and on for RX > > Thanks. > _______________________________________________ > Ntop-misc mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop-misc
signature.asc
Description: Message signed with OpenPGP using GPGMail
_______________________________________________ Ntop-misc mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop-misc
