Thank you Luca. I ran the update and it seems to run without the error now.
It is odd though, since the upgrade the front end GUI now only shows traffic on the dashboard for half of the interfaces. However, when I look at our graphs for the nbox host, I see normal traffic on all of the interfaces. It appears to be cosmetic, but just an observation I wish to share. Also, one quick question. When we are exporting using Netflow v9, are we also exporting IPv6 traffic? Kind regards, Jesse -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Luca Deri Sent: Tuesday, November 22, 2016 4:22 AM To: [email protected] Subject: Re: [Ntop-misc] NPROBE CENTO Out of bounday error Hi Jesse, I have inspected the code, and I believe I have found a case where the bug you reported can be reproduced. I have fixed it and packages are being rebuilt. Please try again later today and let me know if the issue is gone. Thanks Luca On 11/21/2016 09:27 PM, Jesse Alexander wrote: > Hello, > > Beginning today, we are receiving an error when running Cento that I haven't > seen before. I am very new to running Cento, so I suspect I am doing > something wrong and hoping for some assistance. > > I am running Cento ZC on eight 10G Myricom ports to export netflow v9. Not > long after I start running it, I see errors like the following, then it stops > running: > > 21/Nov/2016 02:26:30 [NetflowExporterV9.cpp:172] ERROR: *** Out of bounday > [3493/1470][18952/22 flows] > 21/Nov/2016 02:26:30 [NetflowExporterV9.cpp:172] ERROR: *** Out of bounday > [3557/1470][18953/22 flows] > 21/Nov/2016 02:26:30 [NetflowExporterV9.cpp:172] ERROR: *** Out of bounday > [3621/1470][18954/22 flows] > 21/Nov/2016 02:26:30 [NetflowExporterV9.cpp:172] ERROR: *** Out of bounday > [3685/1470][18955/22 flows] > 21/Nov/2016 02:26:30 [NetflowExporterV9.cpp:172] ERROR: *** Out of bounday > [3749/1470][18956/22 flows] > > I am running the following: > sudo cento -i myri1-1,myri1-2 -i myri2-1,myri2-2 -i myri3-1,myri3-2 -i > myri4-1,myri4-2 -g 4,6,8,9,10,11,12,13,14,15,16,18 -G 2,3,7,17,19,20 --v9 > 10.10.10.2:2055 > > I know the Myricom naming convention is a bit different than default, which > was intentional, but until today it has run great. Only change today is I > added two additional interfaces to export. I am unable to find any online > reference to CPP errors for Netflow v9 to point me in the right direction. > > Thank you in advance, > > Jesse > _______________________________________________ > Ntop-misc mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop-misc _______________________________________________ Ntop-misc mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop-misc _______________________________________________ Ntop-misc mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop-misc
