Hi,
When I run the command which got from the ntop's blog:
nprobe -T ??%IPV4_SRC_ADDR %L4_SRC_PORT %IPV4_DST_ADDR %L4_DST_PORT %PROTOCOL
%IN_BYTES %OUT_BYTES %FIRST_SWITCHED %LAST_SWITCHED %HTTP_SITE %HTTP_RET_CODE
%IN_PKTS %OUT_PKTS %IP_PROTOCOL_VERSION %APPLICATION_ID %L7_PROTO_NAME
%ICMP_TYPE?? ?Ctcp ??127.0.0.1:3333?? -b 2 -i eth0 ?Cjson-labels
it works ok. But after adding another parameter "%HTTP_METHOD", the command
likes the following:
nprobe -T ??%IPV4_SRC_ADDR %L4_SRC_PORT %IPV4_DST_ADDR %L4_DST_PORT %PROTOCOL
%IN_BYTES %OUT_BYTES %FIRST_SWITCHED %LAST_SWITCHED %HTTP_METHOD %HTTP_SITE
%HTTP_RET_CODE %IN_PKTS %OUT_PKTS %IP_PROTOCOL_VERSION %APPLICATION_ID
%L7_PROTO_NAME %ICMP_TYPE?? ?Ctcp ??127.0.0.1:3333?? -b 2 -i eth0 ?Cjson-labels
it will stop with a reason of Segmentation fault within about 30 seconds.
So what's wrong and what should I do?
Thanks.
---------------------
peter.chew
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
