Hello all, I'm a relatively newbie when it comes to ntopng, but I love what I see so far...
I've been setting up an ntopng box using the development version of ntopng so I could experiment with the layer 7 firewall/traffic management. I seem to have managed to get the bridge up an running, but I'm not sure it's working as well as it should be as some of the devices behind the ntopng can't seem to access some of the servers on the wan side of the ntopng. Is there a prefered configuration for the nics that are going to be bridged using ntopng? Right now I have both sides inside my LAN as I only put half my network behind it (so as to not completely cut off my internet access while building this.) My Server has 4 NICs (2 embedded) and a Dual Port Bypass Card from Silicom which is currently operating in Standard NIC mode, so effectively is 2 Intel 1GBit NICs as far as Ubuntu/ntopng is concerned. Should I be setting these ports to promiscuous mode, setting them as static ip devices, or some other way? I'm trying to build it as a bump in the wire setup that would go in place before my Cisco ASA5520 and after my iPrism web filter, so I'm thinking the adapters would work better in promiscuous mode, but I can't seem to get it to play nice. If anyone has a cheat sheet for the Layer 7 recommended setups that would be great. Thanks very much! Robin
_______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop
