That should do it for config. If you do a "show sflow" do you see samples being collected and being exported?
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, March 29, 2005 11:05 AM To: [email protected] Cc: [email protected] Subject: RE: [Ntop] sFlow not working! Here are the command I've used to configure the network foundry switch: sflow enable sflow agent-ip 172.16.2.251 sflow polling-interval 60 sflow destination 172.16.1.215 sflow forwarding # on each interface > A good place to start is to just monitor the interface you should be > seeing the sFlow packets come in on and make sure you see the sFlow > packets themselves come in. If not, I can probably help with your > Foundry config. > > C ********************************************************************** Confidential/Proprietary Note The information in this email is confidential and may be legally privileged. Access to this email by anyone other than the intended addressee is unauthorized. If you are not the intended recipient of this message, any review, disclosure, copying, distribution, retention, or any action taken or omitted to be taken in reliance on it is prohibited and may be unlawful. If you are not the intended recipient, please reply to or forward a copy of this message to the sender and delete the message, any attachments, and any copies thereof from your system. Thank you. Guardian Mortgage Documents, Inc. 225 Union Boulevard, Suite 200 Lakewood, CO 80228. ********************************************************************** _______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop
