Well , I need a subnet for a VOIP Box and few telephones, but if possible using the same Internet connection GuidoElia HELPPC
_____ Da: Mike Hoffman [mailto:[email protected]] Inviato: giovedì 8 ottobre 2009 20.22 A: NT System Admin Issues Oggetto: RE: ADSL router with different subnets on each port If you want a cheaper option then lots of the Netgear models allow additional IP addresses to be added to devices and to reserve the leases. Do you need VLANs, or just routing? Mike From: Rohyans, Aaron [mailto:[email protected]] Sent: 08 October 2009 7:13 PM To: NT System Admin Issues Subject: RE: ADSL router with different subnets on each port Is the built-in ADSL port a requirement? If not, there are plenty of options out there to do what you want... (Cisco 871, 877, ASA 5505, etc) If so, the 857w has a built-in 4 port switch as well as ADSL, but will not allow you to utilize more than 1 wired VLAN. You can, however, use Secondary IPs on the VLAN interface if all you need is for this router to route between two different subnets sitting behind it.... Messy but it'll work. I only bring this up because I happen to have a near brand new one that is sitting in my closet collecting dust J Other option would be to purchase an 1841 or better with 2 WIC slots... throw an ADSL WIC into one slot (also have one of those if you need J) and a HWIC-4ESW to have 4 Ethernet ports. The "el-cheapo" option would be to purchase an old 1721 off of eBay and throw an ADSL WIC + WIC-4ESW (*not* HWIC) into it to achieve the same effect. Hope this helps! Aaron T. Rohyans Senior Network Engineer CCIE #21945, CCSP, CCNA, CQS-Firewall, CQS-IPS, CQS-VPN, ISSP, CISP, JNCIA-ER DPSciences Corporation 7400 N. Shadeland Ave., Suite 245 Indianapolis, IN 46250 Office: (317) 348-0099 Fax: (317) 849-7134 [email protected] http://www.dpsciences.com/ From: HELP_PC [mailto:[email protected]] Sent: Thursday, October 08, 2009 1:40 PM To: NT System Admin Issues Subject: ADSL router with different subnets on each port I am looking for an ADSL router where I can address different subnets (at least 2) on each of the normal 4 port hub included Is it possible ? TIA GuidoElia HELPPC ~ Finally, powerful endpoint security that ISN'T a resource hog! ~ ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/> ~
