Goal is to setup a VLAN for the iSCSI traffic from my Windows Storage Server 2008 box I built.
I can barely spell VLAN so I have my work cut out for me. :) I know I will make a lot of ID10T errors but this is my personal lab so I am not going to hurt anything. If I screw something up, I can just reset the switch back to factory defaults and start all over. Webster > -----Original Message----- > From: Ben Scott [mailto:mailvor...@gmail.com] > Subject: Re: HP ProCurve 2810 CLI ref guide > > On Tue, Oct 27, 2009 at 8:38 PM, Webster <carlwebs...@gmail.com> wrote: > > I must be doing something wrong on my switch as I was told to > > enter "ip routing" but I get "Invalid command: routing". > > The 2810 doesn't do routing. It's a layer two switch. It's not a > router (or a "layer three switch", as routers are sometimes called). > > > I am at the (config)# prompt but can't figure > > out what I am doing wrong. > > What are you trying to accomplish? What's the end goal? ~ Finally, powerful endpoint security that ISN'T a resource hog! ~ ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/> ~
