Ok, too many old, I think... :(. Firmware: [62.J.I]
Regards, Dio. Dio Brando ha scritto: > I'm using a custom cable based on 940-0024C scheme. The acpsmart driver > in debug mode get me this infos: > > # /sbin/apcsmart -DDD /dev/ttyS1 > Network UPS Tools (version 2.0.3) - APC Smart protocol driver > Driver version 1.99.7, command table version 2.0 > debug level is '3' > Attempting firmware lookup > Firmware: [62.J.I] > Not found in table - trying normal method > APC - Attempting to find command set > APC - Parsing out command set > protocol_verify: 0x33 [3] unrecognized > APC - UPS capabilities determined > Detected (null) [(null)] on /dev/ttyS1 > update_info_all: starting > update_info_all: done > dstate_init: sock /var/run/nut/apcsmart-ttyS1 open on fd 5 > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > update_info_normal: starting > update_info_normal: done > Signal 2: exiting > > Thanks. > > Arjen de Korte ha scritto: > >> >>Two things you might check: >> >>1) What cable are you using? >>2) What does the driver mention upon startup? >> >>Note that the info you currently get from upsc, may be all that you will >>ever see. Older APC models will not support more than that. I can't tell >>from the information you provided so far if your UPS is among these >>models. >> >>Regards, >>Arjen >> > > > _______________________________________________ > Nut-upsuser mailing list > Nut-upsuser@lists.alioth.debian.org > http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser > _______________________________________________ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser