>> Asking for UPS status [Q1]...
>> get_data_agiler: raw dump: (0 bytes) =>
>> get_data_agiler: raw dump: (0 bytes) =>
>> Q1 => FAILED [short read]
>> Q1 detail: (0 bytes) =>
>> 5 out of 5 detection attempts failed (minimum failures: 2).
>> Megatec protocol UPS not detected.
>>
>> What does that mean? Sounds like a broken UPS... :-(
>
> Try if adding a different 'subdriver' (see 'man 8 megatec_usb') works.
> This driver also supports one additional subdriver that isn't listed,
> 'agiler-old' (the manpage is outdated in this aspect).
>
> Best regards, Arjen
Tried agiler-old, which failed the same way as the default subdriver. Output
from krauler:
Checking device (0F03/0001) (001/008)
- VendorID: 0f03
- ProductID: 0001
- Manufacturer: Ver 1.0
- Product: USB To RS232 Interface (V1.0) BaudRate 2400bps
- Serial Number: unknown
- Bus: 001
Trying to match device
Device matches
Starting UPS detection process...
Asking for UPS status [Q1]...
set_data_krauler: index [03]
- Unable to fetch string 3
set_data_krauler: connection failure
ser_send_pace: Device detached? (error -27: No error)
==================================================
= device has been disconnected, try to reconnect =
==================================================
Again, there were five attempts to make a connection and all of them failed.
Disconnecting and reconnecting the UPS did not help. This is somewhat strange.
Are there any more subdrivers to try?
Best regards,
Andrej
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
