found the solution: create file /boot/loader.conf and add this line boot-args=''-B acpi-user-options=0x2''
thats it > Am 30.05.2018 um 09:37 schrieb Jürgen Bereuter <j...@matchcut.at>: > > Hello, > i am using a HPE Proliant Gen10 Microserver, i installed omnniosce bloody > (omniosce-bloody-20180509.usb-dd, i had to disable acpi). I am not sure, if i > am using the new bootloader, but i think so. I should now disable acpi, but i > did not find the right config file (/boot/loader.conf: acpi=off). > I tried to switch to grub, but there is also an error message: > > sudo installgrub -fm /boot/grub/stage1 /boot/grub/stage /dev/rdsk/c2t0d0 > open: No such file or directory > Unable to gather device information for /dev/rdsk/c2t0d0 > > The disk is s SSD, with an EFI partition/label, configured at installation as > a rpool. > > When i disable the acpi in the boot options manual omniosce boots up without > a problem, i cannot make it permanent after a reboot. > > thanks! jürgen > _______________________________________________ > OmniOS-discuss mailing list > OmniOS-discuss@lists.omniti.com > http://lists.omniti.com/mailman/listinfo/omnios-discuss
_______________________________________________ OmniOS-discuss mailing list OmniOS-discuss@lists.omniti.com http://lists.omniti.com/mailman/listinfo/omnios-discuss
