We use the sg_map helper but it's slightly more complicated as we only check for the error when the mapping actually gets used. Such that if the mapping failed but wasn't needed then no error occurs.
Signed-off-by: Logan Gunthorpe <log...@deltatee.com> Cc: Ulf Hansson <ulf.hans...@linaro.org> --- drivers/mmc/host/mmc_spi.c | 26 +++++++++++++++++++------- 1 file changed, 19 insertions(+), 7 deletions(-) diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c index 476e53d..d614f36 100644 --- a/drivers/mmc/host/mmc_spi.c +++ b/drivers/mmc/host/mmc_spi.c @@ -676,9 +676,15 @@ mmc_spi_writeblock(struct mmc_spi_host *host, struct spi_transfer *t, struct scratch *scratch = host->data; u32 pattern; - if (host->mmc->use_spi_crc) + if (host->mmc->use_spi_crc) { + if (IS_ERR(t->tx_buf)) + return PTR_ERR(t->tx_buf); + scratch->crc_val = cpu_to_be16( crc_itu_t(0, t->tx_buf, t->len)); + t->tx_buf += t->len; + } + if (host->dma_dev) dma_sync_single_for_device(host->dma_dev, host->data_dma, sizeof(*scratch), @@ -743,7 +749,6 @@ mmc_spi_writeblock(struct mmc_spi_host *host, struct spi_transfer *t, return status; } - t->tx_buf += t->len; if (host->dma_dev) t->tx_dma += t->len; @@ -809,6 +814,11 @@ mmc_spi_readblock(struct mmc_spi_host *host, struct spi_transfer *t, } leftover = status << 1; + if (bitshift || host->mmc->use_spi_crc) { + if (IS_ERR(t->rx_buf)) + return PTR_ERR(t->rx_buf); + } + if (host->dma_dev) { dma_sync_single_for_device(host->dma_dev, host->data_dma, sizeof(*scratch), @@ -860,9 +870,10 @@ mmc_spi_readblock(struct mmc_spi_host *host, struct spi_transfer *t, scratch->crc_val, crc, t->len); return -EILSEQ; } + + t->rx_buf += t->len; } - t->rx_buf += t->len; if (host->dma_dev) t->rx_dma += t->len; @@ -933,11 +944,11 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, } /* allow pio too; we don't allow highmem */ - kmap_addr = kmap(sg_page(sg)); + kmap_addr = sg_map(sg, 0, SG_KMAP); if (direction == DMA_TO_DEVICE) - t->tx_buf = kmap_addr + sg->offset; + t->tx_buf = kmap_addr; else - t->rx_buf = kmap_addr + sg->offset; + t->rx_buf = kmap_addr; /* transfer each block, and update request status */ while (length) { @@ -967,7 +978,8 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, /* discard mappings */ if (direction == DMA_FROM_DEVICE) flush_kernel_dcache_page(sg_page(sg)); - kunmap(sg_page(sg)); + if (!IS_ERR(kmap_addr)) + sg_unmap(sg, kmap_addr, 0, SG_KMAP); if (dma_dev) dma_unmap_page(dma_dev, dma_addr, PAGE_SIZE, dir); -- 2.1.4 -- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To unsubscribe from this group and stop receiving emails from it, send an email to open-iscsi+unsubscr...@googlegroups.com. To post to this group, send email to open-iscsi@googlegroups.com. Visit this group at https://groups.google.com/group/open-iscsi. For more options, visit https://groups.google.com/d/optout.