Hi
is it supported to have one of the ringnumber with a bindnetaddr linked to
an Eth bridge if (br0) ?
because on one config, I have :
rrp_mode : active
and
for 1st ringnumber :
bindnetaddr: 12.1.0.0
for 2nd ringnumber :
bindnetaddr: 12.0.0.0
and ip addr gives :
3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
qlen 1000
link/ether 00:30:48:da:89:23 brd ff:ff:ff:ff:ff:ff
inet 12.1.0.3/16 brd 10.1.255.255 scope global eth1
4: *br0*: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state
UNKNOWN
link/ether 00:30:48:da:89:22 brd ff:ff:ff:ff:ff:ff
inet 12.0.0.3/16 brd 10.0.255.255 scope global br0
and nodes remains UNCLEAN and seem to not exchange tokens between them.
If I keep only the eth1 network, it works fine again.
So is Eth Bridge supported for corosync ?
Or is it a bug fixed in a later release ?
(this config is on fc12 and with corosync-1.1.2-1)
Thanks
Regards
Alain Moullé
_______________________________________________
Openais mailing list
Openais@lists.linux-foundation.org
https://lists.linux-foundation.org/mailman/listinfo/openais
