Hi,

thanks a lot for the answers.

I have added the 'apmd_flags="-C"' to /etc/rc.conf.local and rebooted
and sysctl shows

hw.cpuspeed=600

now but the fans haven't stopped even once in all this time... yes, the
laptop is a bit hot but I'm just reading emails etc and ssh'ing,
nothing that requires a lot of cpu... actually:

load averages:  0.24,  0.34,  0.24                                              
                                                                  
45 processes:  44 idle, 1 on processor
CPU states:  0.6% user,  0.0% nice,  0.2% system,  0.3% interrupt, 98.9% idle
Memory: Real: 98M/222M act/tot  Free: 772M  Swap: 0K/2048M used/tot

  PID USERNAME PRI NICE  SIZE   RES STATE    WAIT     TIME    CPU COMMAND
23347 pau        2    0 3188K   13M sleep    poll     0:09  1.46% kdeinit
29096 _x11       2    0   10M   16M sleep    select   0:08  0.78% Xorg

yes, I'm using kde but using fluxbox doesn't stop the fans, I've already tried.

Also, systat shows:

    1 users    Load  0.34  0.39  0.29                  Tue May  8 18:14:42 2007

                    /0   /10  /20  /30  /40  /50  /60  /70  /80  /90  /100
             <idle> XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Something wrong? I also tried enabling acpi but it doesn't make any difference

Cheers,

Pau

User Kernel Config
UKC> enable acpi
386 acpi0 enabled
UKC> quit
Continuing...
mainbus0 (root)
bios0 at mainbus0: AT/286+ BIOS, date 09/01/04, BIOS32 rev. 0 @ 0xfd720, SMBIOS 
rev. 2.3 @ 0xe8100 (43 entries)
bios0: FUJITSU SIEMENS 0000000000
pcibios0 at bios0: rev 2.1 @ 0xfd720/0x8e0
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfdf40/160 (8 entries)
pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82371FB ISA" rev 0x00)
pcibios0: PCI bus #3 is the last bus
bios0: ROM list: 0xc0000/0xd200! 0xdc000/0x4000!
acpi0 at mainbus0: rev 0
acpi0: tables DSDT FACP SSDT BOOT
acpitimer at acpi0 not configured
acpiprt0 at acpi0: bus 0 (PCI0)
acpiprt1 at acpi0: bus 1 (HUB_)
acpibtn at acpi0 not configured
acpibtn at acpi0 not configured
acpiac at acpi0 not configured
acpibat at acpi0 not configured
acpibat at acpi0 not configured
acpicpu at acpi0 not configured
cpu0 at mainbus0
cpu0: Enhanced SpeedStep 1100 MHz (940 mV): speeds: 1100, 1000, 900, 800, 600 
MHz

_______________________________________________
Openbsd-newbies mailing list
[email protected]
http://mailman.theapt.org/listinfo/openbsd-newbies

Reply via email to