Dear OpenCPI gurus - In my attempt to wrap my head around OpenCPI I am stuck with the following task:
I have a SDR transceiver (TRX) (see http://www.adat.ch - that's the device in question) that I like to control via OpenCPI-based control software. The TRX has four independent VFOs (variable frequency oscillators) for RX covering 0.1 to 30 MHz. In addition there's one TX (sender) covering the same range. The TRX is comprised of three logical components: The DSP board, the Channel Memory, and the Graphical User Interface (GUI). The GUI has its own processor. The DSP board and the GUI require firmware to be loaded into the respective processor's flash memory. The TRX sports a USB interface with its own high-level protocol. Example: "$FRA! 30.0000" -> Set frequency of VFA A immediately to 30 MHz. Other commands are available for uploading the firmware packages. Now ... What would be a suitable start in formulating properties and operations ? I can't seem to find a "good" way ... Any hint/advice/direction really appreciated... Thanks !! Regards Frank _______________________________________________ opencpi_dev mailing list [email protected] http://lists.opencpi.org/listinfo.cgi/opencpi_dev-opencpi.org
