Hi Rafiu, Thanks for that. You may not know the answer to this but does this mean that if I configure the raid settings in the bios for RAID 0 and the drivers on Openfiler work properly that the drives should appear as one large drive in the the disk partitioning section of the install?
I ask because even though everything to do with the raid config is set in the bios and the drives appear as a single striped drive there they still appear as two separate drives in Disk Druid. The option to software raid them is there but if the drivers are loaded properly shouldn't they already appear as a raid and therefore as a single drive? >Hi Glenn, >According to the DFI website, that board has two SATA chipsets: nForce4 >and Silicon Image. >The Silicon Image should be supported by Openfiler 1.1. >Both Silicon Image and nForce4 should be supported by Openfiler 2.0. >The respective kernel driver modules are sata_nv and sata_sil. >Cheers, >Rafiu. -- Glenn McCarter Digital Lucida 478-480 Rathdowne St Carlton North Ph 03 9349 5159 Fax 03 9349 5153 _______________________________________________ Openfiler-users mailing list [email protected] https://lists.openfiler.com/mailman/listinfo/openfiler-users
