Re: [OF-users] Re: Fresh smp install boot problemsOkay, the 64-bit ISO is not dual-arch so it calls into question Mr. Smith's technical prowess when it comes to "Network and System Administration" ;) but with regard to the error on boot... it looks like problem upstream of OF that is likely to have been fixed in a subsequent rpath kernel patch release. It's been a while since I've had to pay attention during install, but doesn't the rpath ISO include the option to install from the network or was that only the Centos-based OF ISO? If it does, you'll have to pass the relevant boot option at the first login screen. Default is <enter> which fires off the local cdrom install. You want to specify to install from the network (if the option is availble). It will take quite some time but it should include updated patches to the kernel which may resolve your problem.
This is all a guess on my part as I've not tried it and I seem to be cutting my rpath teeth on a daily basis so YMMV. Good luck, -=dave ----- Original Message ----- From: dave johnson To: [email protected] Sent: Saturday, April 14, 2007 9:59 PM Subject: Re: [OF-users] Re: Fresh smp install boot problems I was under the impression that the 64-bit iso wasn't a dual-platform install and thus did not include the 32-bit install capability. Apparently I'm wrong ? -=dave ----- Original Message ----- From: Smith, Al To: [EMAIL PROTECTED] ; [email protected] Sent: Saturday, April 14, 2007 6:54 PM Subject: Re: [OF-users] Re: Fresh smp install boot problems Install the 64 bit version from rpath I had the same problem and that resolved it. -Al Al Smith Network and Systems Administrator [EMAIL PROTECTED] (610) 968-1239 (o) (484) 886-6216 (c) -----Original Message----- From: [EMAIL PROTECTED] To: [email protected] Sent: Sat Apr 14 00:20:28 2007 Subject: [OF-users] Re: Fresh smp install boot problems Anyone? 2007/4/13, Tommi Paajanen <[EMAIL PROTECTED]>: Hey, Just installed Openfiler 2.2 on my Dual P3 733 machine. Installed Openfiler on 160Gb ATA disk. I also have two ATA PCI cards with 4x250Gt ATA disks I'm going to use in software RAID5 array. Install went without any errors. But when I boot up the system I get this error: "Bad page state in process swapper" https://www.openfiler.com/community/forums/viewtopic.php?pid=3208 <https://www.openfiler.com/community/forums/viewtopic.php?pid=3208> Similar problem, no help. ---------------------------------------------------------------------------- _______________________________________________ Openfiler-users mailing list [email protected] https://lists.openfiler.com/mailman/listinfo/openfiler-users ------------------------------------------------------------------------------ _______________________________________________ Openfiler-users mailing list [email protected] https://lists.openfiler.com/mailman/listinfo/openfiler-users
_______________________________________________ Openfiler-users mailing list [email protected] https://lists.openfiler.com/mailman/listinfo/openfiler-users
