[EMAIL PROTECTED] wrote:
Hello,
I’m using OF 2.2, and I’m having a problem getting OF to detect one of
my ethernet cards.
I have 3 NICs on my PC : an on-board ethernet controller (Realtek
8111C), and 2 D-Link DGE-528T ethernet cards. During installation, OF
picked up the on-board controller (as *eth0*), plus one of the D-Link
cards (as *eth1*). It’s rather strange that the 2^nd D-Link card was
not detected, seeing as it’s exactly the same model as the other one.
Anyway, the on-board controller isn’t working properly (I suspect
that’s because there is no Linux driver for it), but that doesn’t
matter too much, as I really wanted to use the 2 D-Link cards (one for
the public network, the other one for a private network).
My question is – how can I now (i.e. after having done the
installation) configure the network to include the 2^nd D-link
ethernet card. If it was a full version of Red Hat Linux, for example,
I could have used a GUI tool called *system-config-network*, but
unfortunately the latter doesn’t exist on the version of Linux that
comes with OF.
I’d be most grateful for any ideas on that subject.
Regards,
Reg TAMAN
Taman,
There are numerous howto's available, ie:
http://www.fdlinux.com/networksetuphowto.html
http://www.brennan.id.au/04-Network_Configuration.html
-Patrick
_______________________________________________
Openfiler-users mailing list
[email protected]
https://lists.openfiler.com/mailman/listinfo/openfiler-users
