Hi,
I got more details for this: in my testing when the concurrent connections
through gnuGK-3.6(H.460.18/19 enabled) reached about 130, then when I tried
to connection one more terminal in, Wireshark shows that gnuGK sent out a
ReleaseComplete message thus the call is failed; at this time if I
disconnect one call and join that terminal again, then it is successfully.
it seems that when the concurrent calls reach a specific value(in my
testing it is about 130), then gnuGK will send out ReleaseComplete message
for the new call. could you give me some clues why this will happen? which
part of the source code I need to read for this? can I control it by
config-file? Thanks!
Regards,
Bo Xu
On Wed, May 7, 2014 at 1:59 PM, Bo Xu <[email protected]> wrote:
> Hi,
>
> I am doing stress testing of the maximum connection number of
> gnuGK(H.460.18/19 enabled) now. with gnuGK3.6(H.460.18/19 enabled) I can
> connect 124 terminal-simulators into our MCU through gnuGK3.6, but I cannot
> connect more terminals in, the CPU usage of gnuGK is stable at about 65%,
> so I think it is still possible to add more terminals in, but I cannot. is
> there any maximum connection limitation for gnuGK3.6? is there a parameter
> in the config file so I can set it and increase it? Thanks!
>
> Regards,
> Bo Xu
>
------------------------------------------------------------------------------
Is your legacy SCM system holding you back? Join Perforce May 7 to find out:
• 3 signs your SCM is hindering your productivity
• Requirements for releasing software faster
• Expert tips and advice for migrating your SCM now
http://p.sf.net/sfu/perforce
_______________________________________________________
Posting: mailto:[email protected]
Archive:
http://sourceforge.net/mailarchive/forum.php?forum_name=openh323gk-users
Unsubscribe: http://lists.sourceforge.net/lists/listinfo/openh323gk-users
Homepage: http://www.gnugk.org/
