Quoting r. Roland Fehrenbacher <[EMAIL PROTECTED]>: > Subject: Re: Flashing Mellanox MT23108 > > >>>>> "Michael" == Michael S Tsirkin <[EMAIL PROTECTED]> writes: > > Michael> Quoting r. Jerome Pioux <[EMAIL PROTECTED]>: > > >> I don't know about mstflint but I used flint in the past from > >> IBGD so it may be the same? With flint, you need to use the > >> raw image (bin) and not the Mellanox one (mlx). This is what I > >> used: > > Hi Jerome, > > thanks for your help. I knew 'Mellanox flint'. The disadvantage of it > is that it needs all the drivers loaded, while flint goes directly on > the PCI device. > > >> flint -d /dev/mst/mt23108_pci_cr2 -i > >> /etc/ibfw/fw/fw-cougar-a1-3.3.2-jerome.bin b Image type: > >> FailSafe Chip rev.: A1 GUIDs: 0005ad0000016770 0005ad0000016771 > >> 0005ad0000016772 0005ad000100d050 Board ID: � > >> > >> Burn image with the following GUIDs: Node: 0005ad0000016770 > >> Port1: 0005ad0000016771 Port2: 0005ad0000016772 Sys.Image: > >> 0005ad000100d050 etc... > >> > >> I think that I created the bin image using infiniburn. I read > >> fw-23108-a1-rel.mlx using infiniburn and write the bin image > >> (raw format). But if you have infiniburn working, I think that > >> you can burn the mlx image directly. > > >> ----- Original Message ----- > >> > >> From: Roland Fehrenbacher To: [email protected] Sent: > >> Thursday, April 07, 2005 5:38 AM Subject: [openib-general] > >> Flashing Mellanox MT23108 > >> > >> Hi, > >> > >> can anyone tell me how to flash a Mellanox MT23108 card with > >> mstflint. When I try the firmware file fw-23108-a1-rel.mlx from > >> Mellanox I get > >> > >> $ mstflint -d /proc/bus/pci/03/00.0 -i fw-23108-a1-rel.mlx b > >> Not a valid image > > Michael> With mstflint you pass in the device location: -d 03:00.0 > Michael> Otherwise its the same. > > Unfortunately, now even with the raw image prepared by using infiniburn > from fw-23108-a1-rel.mlx and the correct .brd, I get > > mstflint -d /proc/bus/pci/03/00.0 -i fw-23108.bin b > /0x00030028/ (BOOT2) - read error (Address (0x3002c) is out of image limits > ) > Not a valid image > > Roland >
I'll check this on Sunday. What does mstflint -d 03:00.0 v show? -- MST - Michael S. Tsirkin _______________________________________________ openib-general mailing list [email protected] http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
