Hal Rosenstock wrote: > On Wed, 2006-09-20 at 01:05, Michael S. Tsirkin wrote: > >> Quoting r. Hal Rosenstock <[EMAIL PROTECTED]>: >> >>> Subject: Re: gen2_basic patch 5/10: select a valid port number >>> >>> On Tue, 2006-09-19 at 21:16, Robert Walsh wrote: >>> >>>> Hal Rosenstock wrote: >>>> >>>>> On Tue, 2006-09-19 at 20:28, Robert Walsh wrote: >>>>> >>>>>> gen2_basic - select a valid port number >>>>>> >>>>>> Port numbers start at 1, not 0. >>>>>> >>>>> True for CA and routers but not switches. >>>>> >>>> Yeah. Does anyone run gen2_basic on switches, though? I assumed it was >>>> HCA-centric. >>>> >>> Yes, that appears to be the scope but I'm not 100% sure. >>> >> Its easy to get linux running on a switch, so why not? You just >> need to write a low level driver that cn send/receve MADs. >> We did run a gen1 port on a switch at some point, and someone might want to >> do it again. >> > > And the only limitation would be what switch port 0 (extended, base) > supports relative to these tests. > > -- Hal > Hi.
This test was written in order to check the verbs layer and it was developed over an HCA (and being executed every day on all of our HCAs). I don't know what is the expected result of executing this test over a switch and if there should be some changes in order to check switch features. If I'll get this input, i will add the needed features/code to the test. Dotan _______________________________________________ openib-general mailing list openib-general@openib.org http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
