-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
what is correct setting for the debug board? i want to use Jtag(run openocd) and serial port(uart) simultaneously and, here i can only see one /dev/ttyUSB0, while running openocd according to wiki(http://wiki.openmoko.org/wiki/Debug_Board/es) there should be a /dev/ttyUSB1 for serial port? i can see polling is success when running the code, so data should output.. Dennis.Yxun wrote: > the most frustrating is that NOTHING output to my minicom, > > IMHO, the reson it not work would be the incorrect uart clock > so it may mismatch with the host baudrate setting... > > and also, i confirmed that FR use UART2 as serial console output from wiki > > On Thu, Jul 24, 2008 at 11:57 PM, Andy Green <[EMAIL PROTECTED]> wrote: > > Somebody in the thread at some point said: > > | 2. config uart clock source as PCLK, 16Mhz, > > Make sure you set the GPIO registers for these pins to be in peripheral > mode not GPIO. See GPHCON. > > >> yes, i've enabled those UART to functional mode > > There's also a peripheral clock mask register CLKCON, it says it resets > to all enabled though. > > >> and the clock is enable. > > -Andy >> -----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.7 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFIil/v28unoHSQkyIRAsLOAJ0RIIsblmHfKeaN+wBxZbbKkp2WJACfbXFf MhVd91N8mV0qbSdp7SFf4a8= =98yx -----END PGP SIGNATURE-----
