Hello, all. I have OpenOCD (svn:1013) and I try to debug linux kernel on Toradex Colibri board (PXA270) via Wiggler JTAG. When I issue 'reset run' command to openocd daemon, u-boot load and _start_ linux succefully, but after self-extraction phase, linux mutually stop: "Uncompressing Linux....................... done, booting the kernel." - this is last message. When I press reset button, linux start and works fine. So, xscale code into OpenOCD incorrectly work with PXA270 JTAG-TAP ? May be, I can use any workaround for aviod this ?
PS: on at91rm9200-based board, "reset run" works fine: linux boot & work OK. Thank you. -- Regards, Alexei Babich, circuit engineer, OOO NPP "Rezonans", Chelyabinsk, Russia http://www.rez.ru Jabber ID: [EMAIL PROTECTED] _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
