Now I have completely taken Eclipse out of the picture, and am just using openOCD and GDB 6.8.
I still am stuck and no breaky points ! I am following a template that was provided, this was helpfull but is not my solution it seems. //================================================ Joe, Try adding this to your configuration file #---- gdb_memory_map enable #---- This tells openocd to inform GDB where 'flash lives' - thus GDB will attempt to use hardware breakpoints. ===== Specify the ELF file... ===== (gdb) file ./bin/basic-internalflash-project-at91sam3u-ek-at91sam3u4-flash.elf Reading symbols from /home/duane/cortex/b/basic-internalflash-project-at91sam3u-ek/basic-internalflash-project/bin/bas ic-internalflash-project-at91sam3u-ek-at91sam3u4-flash.elf...done. ===== Specify the target ===== (gdb) target remote 192.168.0.100:3333 Remote debugging using 192.168.0.100:3333 0x00000000 in ?? () !!!!!!!!!! in my case !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! (gdb) target remote localhost:3333 ===== Tell openocd to HALT the target ===== (gdb) mon halt ===== Tell openocd to RESET the target. ===== (gdb) mon reset JTAG tap: sam3.cpu tap/device found: 0x4ba00477 (mfg: 0x23b, part: 0xba00, ver: 0x4) JTAG Tap/device matched ===== And i tell it to halt again... ===== (gdb) mon halt target state: halted target halted due to debug-request, current mode: Handler BusFault xPSR: 0x21000005 pc: 0x000817dc ===== Load my program - this actually programs the flash ===== (gdb) load Loading section .fixed, size 0x133c lma 0x80000 Loading section .relocate, size 0xf4 lma 0x8133c Start address 0x811dc, load size 5168 Transfer rate: 4 KB/sec, 2584 bytes/write. ===== Set a breakpoint at "main()" ===== (gdb) break main Breakpoint 1 at 0x800c0: file main.c, line 168. ===== Tell GDB to continue - see the NOTE from GDB... ===== (gdb) cont Continuing. Note: automatically using hardware breakpoints for read-only addresses. ===== I hit my breakpoint.. ===== Breakpoint 1, main () at main.c:168 168 TRACE_CONFIGURE(DBGU_STANDARD, 115200, BOARD_MCK); (gdb) ===== Works for me :-) ===== //================================================ Does not work for me, yet anyways. Please check out my attachements, incuded is 1) June26AttemptsB1.pdf ==>>> Screen shots of exactly what I sent to gdb. 2) openocdLog26B1.txt ==>>> Level 3 debug trace, for tracking communications between gdb and openOCD. 3) ConfigFiles_June26Attempt.7z
_______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
