Dne Po 31. května 2010 09:49:18 Mars Steeve napsal(a): > Hi Marek, > > I finally received my JTAG KEY Tiny and successfully compiled OpenOCD 0.4.0 > with your patches. > > Unfortunately, I'm unable to flash or debug my board (colibri pxa320), the > CPU is never halted. > > I post the result of "reset halt". > > $ openocd -f interface/jtagkey-tiny.cfg -f board/colibri_pxa320.cfg > > > reset halt > > JTAG tap: colibri_pxa320.cpu tap/device found: 0x7e642013 (mfg: 0x009, > part: 0xe642, ver: 0x7) Bad value '00' captured during DR or IR scan: > check_value: 0x02 > check_mask: 0x07 > JTAG error while writing DCSR > Bad value '00' captured during DR or IR scan: > check_value: 0x02 > check_mask: 0x06 > JTAG error while reading TX > error while polling TX register, reset CPU > target state: halted > target halted in ARM state due to target-not-halted, current mode: User > cpsr: 0x00000000 pc: 0x00000000 > MMU: disabled, D-Cache: disabled, I-Cache: disabled > > Thanks for your help!
I saw this with my vpaclink on Zylonite PXA320. By using the homemade JTAGkey, it worked. I assume there's a problem with not enough drive strength on some JTAG adapters. Maybe try adding a buffer past the adapter. _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
