Hi,
It seems there is an issue with build 122 and using a HBA in target mode where
the link gets disconnected.
I installed SXCE build 122 and imported an existing pool. I then upgraded the
pool version (now I cannot go back).
I have tried 3 different adapters:
Emulex LP9002 PCI-X (1st I used the fw that was a few revisions back and then
update to latest)
Emulex LP1102 PCI-X (failed then also upgraded to the latest firmware, still
failed)
Emulex LPe11000 PCIe (also failed)
The system was working fine before the install of the latest build. Build 99
works fine.
What happens is that the link is established and immediately disconnect:
bash-3.2# stmfadm list-target -v
Target: wwn.10000000C----4
Operational Status: Online
Provider Name : emlxs4
Alias : emlxs4
Sessions : 0
HBA Port WWN: 10000000-----4
Port Mode: Target
Port ID: 0
OS Device Name: Not Applicable
Manufacturer: Emulex
Model: LPe11000-E
Firmware Version: 2.50a6 (Z2D2.50A6)
FCode/BIOS Version: none
Serial Number: VM72509657
Driver Name: emlxs
Driver Version: 2.40s (2009.07.17.10.15)
Type: unknown
State: offline
Supported Speeds: 1Gb 2Gb 4Gb
Current Speed: not established
Node WWN: 20000000c9695ba4
After trying to connect to the target:
Sep 16 08:39:28 ----- emlxs: [ID 349649 kern.info] [ 5.0616]emlxs4: NOTICE:
730: Link reset. (Disabling link...)
Sep 16 08:39:28 ----- emlxs: [ID 349649 kern.info] [ 5.034A]emlxs4: NOTICE:
710: Link down.
Target: wwn.10000000-----4
Operational Status: Offline
Provider Name : emlxs4
Alias : emlxs4
Sessions : 0
HBA Port WWN: 10000000-----4
Port Mode: Target
Port ID: 1
OS Device Name: Not Applicable
Manufacturer: Emulex
Model: LPe11000-E
Firmware Version: 2.50a6 (Z2D2.50A6)
FCode/BIOS Version: none
Serial Number: VM72509657
Driver Name: emlxs
Driver Version: 2.40s (2009.07.17.10.15)
Type: L-port
State: offline
Supported Speeds: 1Gb 2Gb 4Gb
Current Speed: 4Gb
Node WWN: 20000000c9695ba4
Only a reboot can bring the target state back online.
This behavior is the same for all adapters.
Unfortunately I do not have any Qlogic HBA?s that support target mode. I have
the QLE220 range.
Can someone please indicate if they are using build 122 with an Emulex HBA in
target mode or have any ideas as to what I can try to access the system as a
target.
Any input would be greatly appreciated.
This is a fairly critical issue to me.
Thanks.
--
This message posted from opensolaris.org
