Hey folks,
I've been wanting to use Solaris for a while now, for a ZFS home storage server
and simply to get used to Solaris (I like to experiment). However, installing
b70 has really not worked out for me at all.
The hardware I'm using is pretty simple, but didn't seem to be supported under
the latest Nexenta or Belenix build. It seems to work fine in b70 SXCE...with
a few catastrophic problems (counterintuitive I know, but hear me out).
I haven't yet managed to get the Webstart hardware analyzer to work on this
system (no install, ubuntu liveCDs seem to not want to install a jdk for some
reason), so I'm really not sure that the hardware is "supported", but as I said
everything seemed to work fine in the installer and then initializing the ZFS
pool (I'd just like to say how shockingly simple it was to create my zpool -- I
was amazed!).
The hardware is:
3.0ghz P4 socket 775
Intel 965G desktop board ("Widowmaker")
3x 400GB SATA drives (ZFS RaidZ)
1x 100GB IDE drive (UFS boot)
I added a SI 2 port PCI SATA controller, but it seemed to not be recognized so
I am not using it.
The problems I'm experiencing are as follows:
ZFS creates the storage pool just fine, sees no errors on the drives, and seems
to work great...right up until I attempt to put data on the drives, or schedule
a scrub. After only a few moments of transfer, things start to go wrong. The
system doesn't power off, it just beeps 4-5 times. The X session dies and the
monitor turns off (doesn't drop back to a console). All network access dies.
It seems that the system panics (is it called something else in solaris-land?).
The HD access light stays on (though I can hear no drives doing anything
strenuous), and the CD light blinks.
This happens every time I attempt to transfer data to the ZFS storage pool.
Data transfers to the UFS partition seems to work fine, and when I reboot
everything seems to be working again.
When I did a zfs scrub on the storage pool, the system crashed as usual, but
didn't come back up properly. It went to a disk cleanup root password prompt
(which I couldn't enter because I didn't have USB legacy mode enabled and
apparently USB isn't supported until the OS is fully booted and I didn't have a
spare PS2 keyboard to use on that system).
This is really bothersome, since I really was looking forward to the ease of
use and administration of ZFS versus Linux software RAID + LVM.
Can anybody shed some light on my situation?
As a side note, this so far is entirely experimental for me...I haven't even
gotten the chance to get any large amount of data on the ZFS pool (~650MB so
far), so I have no problem reinstalling, changing around hardware, swapping
board & processor out for something different (I have several systems with some
potential to be good storage servers that I don't mind moving around).
Thanks!
This message posted from opensolaris.org
