Hi Steve,
I have used ‘ocata’ bits to created tripleo setup. Because don’t have pike bits
yet.
I am not sure only upgrading tripleo-common will be sufficient or not.
Is there any wan where I can upgrade my setup to ‘master’ ?
Thanks,
Dnyaneshwar
On 6/29/17, 1:56 PM, "Steven Hardy" <sha...@redhat.com> wrote:
On Thu, Jun 29, 2017 at 7:07 AM, Dnyaneshwar Pawar
<dnyaneshwar.pa...@veritas.com> wrote:
> Hi,
>
>
>
> I am getting following error. Do I need to specify anything else in the
> command?
>
> This command was working fine before commit
> 3e6147dee4497bbb607e6377bd588e32f62be2b7 .
There is a Depends-On: I961624723d127aebbaacd0c2b481211d83dde3f6 -
have you updated tripleo-common and re-run openstack undercloud
install?
There is some coupling between changes in tripleo-heat-templates and
tripleo-common mistral actions/workbooks, so if you don't update both
parts it's likely things won't work as expected.
Steve
__________________________________________________________________________
OpenStack Development Mailing List (not for usage questions)
Unsubscribe: openstack-dev-requ...@lists.openstack.org?subject:unsubscribe
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
__________________________________________________________________________
OpenStack Development Mailing List (not for usage questions)
Unsubscribe: openstack-dev-requ...@lists.openstack.org?subject:unsubscribe
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
