Hello everybody: Ok, I am a total beginner when it comes to install Suse on an embedded board.
I got an ARM board on Ebay from Forlinx embedded. Nice piece of hardware and planing to use to control an exotic piece of laboratory equipment. OK210 (you can search on Ebay for it) Architecture: Cortex-A8 Processor: Samsung S5PV210 chip 512MB of DDRII 1GB of flash 1GHZ clock I took a look a the wiki... given that the board is obviously not on the list. I downloaded the files (still deciding which one to use): openSUSE-13.1-ARM-JeOS.armv7-rootfs.armv7l-1.12.1-Build33.1.tbz and openSUSE-13.1-ARM-JeOS.armv7-rootfs.armv7l-1.12.1-Build33.1.tbz The instructions and wiki are not exactly great for non hardcore programmers. "And make your own SD card to boot on, with first bootloader (manufacturer specific), U-Boot (configured for your board) and a kernel (configured for your board) if openSUSE does not provide it" Could anybody explain or point out where I can get more information on actually how to do it???? I am sort of clueless..... willing to share all what I get done on this little board. Thank you "Do not spend too much time in the lab, or you will get a one pack!!" (Instead of a six pack abs!!) "Do not spend too much time in the lab, or you will get a one pack!!" (Instead of a six pack abs!!) -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
