Greetings, I have successfully installed and run this JeOS for the Raspberry Pi:
openSUSE-13.1-ARM-JeOS-raspberrypi.armv7l-1.12.1-Build38.1.raw Dated: 23-Jun-2014 Downloaded from: http://download.opensuse.org/repositories/devel:/ARM:/13.1:/Contrib:/RaspberryPi/images/ But have noticed odd behavior with the filesystem tree. Specifically, running 'mount' produces this output: <SNIP> mqueue on /dev/mqueue type mqueue (rw) debugfs on /sys/kernel/debug type debugfs (rw) devpts on /dev/pts type devpts (rw,mode=0620,gid=5) proc on /proc type proc (rw) configfs on /sys/kernel/config type configfs (rw) /run on /var/run type none (rw,bind) /run/lock on /var/lock type none (rw,bind) <SNAP> And the output of df -h: <SNIP> Filesystem Size Used Avail Use% Mounted on /run 187M 1.1M 186M 1% /var/run <SNAP> It would appear that no root filesystem is mounted. And looking at /etc/mtab we see: <SNIP> mqueue /dev/mqueue mqueue rw 0 0 debugfs /sys/kernel/debug debugfs rw 0 0 devpts /dev/pts devpts rw,mode=0620,gid=5 0 0 proc /proc proc rw 0 0 configfs /sys/kernel/config configfs rw 0 0 /run /var/run none rw,bind 0 0 /run/lock /var/lock none rw,bind 0 0 <SNAP> Additionally, /etc/fstab contains only these entries: <SNIP> devpts /dev/pts devpts mode=0620,gid=5 0 0 proc /proc proc defaults 0 0 <SNAP> Which seems to confirm that there is no root fs. But if we look at fdisk -l: <SNIP> Disk /dev/mmcblk0: 7948 MB, 7948206080 bytes, 15523840 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk label type: dos Disk identifier: 0xa7e6536d Device Boot Start End Blocks Id System /dev/mmcblk0p1 * 2048 485383 241668 c W95 FAT32 (LBA) /dev/mmcblk0p2 487424 1980415 746496 83 Linux <SNAP> The structure looks ok (only missing a swap partition). If we try to use YaST to resize /dev/mmcblk0p2, we get an error saying the filesystem seems to be inconsistent. But then we try to run fsck /dev/mmcblk0 it tells us: <SNIP> fsck from util-linux 2.23.2 e2fsck 1.42.8 (20-Jun-3013) /dev/mmcblk0p2 is mounted. e2fsck: Cannot continue, aborting. <SNAP> This, plus the fact that the system runs fine seem to indicate that the root fs is actually mounted. I found the situation a bit puzzling, and would be interested to hear any thoughts on it. As a side note, it is possible to resize the root partition in a second computer using YaST and then install software from the on-line repos. -Alex -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
