Hi

openSUSE-13.1-ARM-JeOS-beaglebone.armv7l-1.12.1-Build38.9.raw

second-boots fine, just checked. Could you show full log of the first boot?


14.10.2014 05:17, lists пишет:
> On Mon, 13 Oct 2014 01:19:16 -0700
> lists <[email protected]> wrote:
> 
>> The title says it all. No HDMI on this specific build.
>> openSUSE-13.1-ARM-JeOS-beaglebone.armv7l-1.12.1-Build38.9.raw.xz
>>
>> Otherwise, it boots/runs. I'm going to flog it a bit more. 
> 
> This image seems to have other problems. I used zypper update, then
> issued the reboot command. The display on the serial port got to
> "starting kernel" and just froze there.
> 
> I did a reboot by hand (i.e. hold the boot button and apply power).
> ---------------------------------------------
> U-Boot 2013.04 (Mar 17 2014 - 15:34:07)
> 
> I2C:   ready
> DRAM:  512 MiB
> WARNING: Caches not enamusb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs,
> HB-ISO Rx, HB-ISO Tx, SDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4
> musb-hdrc: 28/31 max ep, 16384/16384 memory
> USB Peripheral mode controller at 47401000 using PIO, IRQ 0
> musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx,
> SoftConn) musb-hdrc: MHDRC RTL version 2.0 
> musb-hdrc: setup fifo_mode 4
> musb-hdrc: 28/31 max ep, 16384/16384 memory
> USB Host mode contnot set. Validating first E-fuse MAC
> cpsw, usb_ether
> Hit any key to stop autoboot:  0 
> mmc0 is current device
> SD/MMC found on device 0
> 1950 bytes read in 6 ms (317.4 KiB/s)
> Running bootscript from mmc0 ...
> ## Executing script at 80200000
> kerneladdr=0x802000004504224 bytes read in 609 ms (7.1 MiB/s)
> ** File not found initrd **
> 21959 bytes read in 24 ms (892.6 KiB/s)
> ## Flattened Device Tree Tree in pla885c6
> 
> Starting kernel ...
> 
> ------------------------------
> Again, nothing happens. To be sure, I went to the HDMI port, just to
> see if the display got transferred there, and again, nothing.
> 
> At this point, I'm going to halt testing and wait until someone thinks
> there is an image with HDMI support. 
> 


-- 
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]

Reply via email to