Hallo Leute, Am Montag, 20. Februar 2006 17:40 schrieb David Barker: > On 2/19/06, James PEARSON <[EMAIL PROTECTED]> wrote: > > > I have a strange problem when installing beta4 into VMware 4.5.2: > > > CD1 and CD2 are installed without problems, but CD3 is not > > > recognized - YaST keeps asking for it. [...] > > I had the same problem except that I am using the latest Vmware > > v5.5 (VMware-workstation-5.5.1-19175).
My main question is still open - is this a known bug or should I report it? > > The install process blocked when I gave it the 3rd CD. After hiting > > ENTER a couple of times, I finally chose "Ignore" and voila, I had > > the same problem for the 4th CD. I chose "Ignore" again and the > > install process asked for the 5th CD. The 5th CD ran without any > > problems and the installation continued up I didn't need CD 4 and 5 - but that sounds like a funny effect. > > until "Hardware Configuration" page setup where there is still a > > problem on the "Hardware Configuration" setup page. You mean the box says "system analyses" forever? (translated back from german, but you should get the point) I just skipped it and didn't notice problems yet ;-) > > I believe that is last problem > > is related to Sax2 configuration process under Vmware. > > I was able to chose eject and then ok to continue with the install > however sax2 can't configure the xserver even after installing the > vmware tools. Try sax2 -m 0=vesa as workaround (found in Bug 148211) - this worked for me (IIRC only after a "init 6") Regards, Christian Boltz -- > Es steht dir frei, dich auch auszutragen, damit du von Idioten wie > David, Thorsten, Bernd, ... nicht weiter belästigt wirst. Und ich gehöre da nicht mehr dazu? [> Matthias Houdek und Florian Gross in suse-linux] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
