On Fri, 2007-01-12 at 07:33 +0800, Joe Morris (NTM) wrote: > Art Fore wrote: > > Anyhow, I got them both working. I setup Yast to use traditional > > control, then set the eth0 as it was default from the installation. Then > > set eth1 DNS servers etc. so DHCP would not update them. Then executed > > the command route add gw 192.168.99.1. I could then access the wireless > > network via Linux with not change in WinXP. > > > > Only remaining problems are how to get ifplugd to start the wireless at > > boot. > Change it in Yast to startup at boot instead of on cable connection > (Network Devices, Network Card, Edit your card, General Tab). > > eth1 was added to the ifplugd.conf file, but probably needs more > > time or something. Also have figure out where to put the route command > > so it will be executed automatically during boot. > > > > > Under Address tab, Routing > > -- > Joe Morris > Registered Linux user 231871 running openSUSE 10.2 x86_64 > >
That appears to have done it. Will find out for sure Monday when I go back to work. Art > -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]