Herbert Georg wrote: > Hi there, > > I installed the latest Nvidia driver and it detected correctly my > graphics card and monitor. And assigned correctly the sync ranges. I'm > using the 1280x1024 mode. > But I wanted to lower the monitor frequencies to do a test. So I opened > sax2 and lowered the maximum values. But when I test the sax2 > configuration it shows me the old high frequency values. Even if I save > the configuration (and looking at the /etc/X11/xorg.conf the ranges are > correctly modified) sax2 keeps on showing the old high values. Same if I > restart X. > My modified ranges are: HorizSync 28-65 kHz and VertRefresh 56-60 Hz. > But sax2 says, in that test screen, that the current values are 80kHz > and 75Hz. > > So, is sax2 not showing the actual values or X is not using the values > in the range? > How can I be sure about the frequencies actually being used? Is there a > command that shows me this information?
xvidtune And/or you can use your monitors "online" display. There usually is an "Info"-item in the monitor setup menu that should display the monitor settings. regards Eberhard -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]