Hello list

I build a fresh kamikaze trunk checkout rev 12763 an flashed it onto an alix 
2c3 with a wistron cm9 installed.

The trouble begins, when I add a "countrycode=276" to /etc/modules.d/50-madwifi 
as I always did.
The board hang completely ... no oops, no reaction on serial console and no 
ping. The last lines I can see are:

- preinit -
Press CTRL-C for failsafe
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
- init -

Please press Enter to activate this console. PPP generic driver version 2.4.2
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <[EMAIL PROTECTED]>
ip_tables: (C) 2000-2006 Netfilter Core Team
nf_conntrack version 0.5.0 (4096 buckets, 16384 max)
Registered led device: alix:1
Registered led device: alix:2
Registered led device: alix:3
wlan: trunk
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 2008-09-09 (AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, 
RF5413, RF2133, RF2425, REGOPS_FUNC, DFS, XR)
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (trunk)
ath_rate_minstrel: look around rate set to 10%
ath_rate_minstrel: EWMA rolloff level set to 75%
ath_rate_minstrel: max segment size in the mrr set to 6000 us
wlan: mac acl policy registered
ath_pci: trunk
Atheros HAL provided by OpenWrt, DD-WRT and MakSat Technologies
wifi0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 
36Mbps 48Mbps 54Mbps
wifi0: turboA rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
ath_pci: wifi0: Atheros 5212: mem=0xe0080000, irq=9
ne2k-pci.c:v1.03 9/22/2003 D. Becker/P. Gortmaker
via-rhine.c:v1.10-LK1.4.3 2007-03-06 Written by Donald Becker
eth0: VIA Rhine III (Management Adapter) at 0xe0000000, 00:0d:b9:14:23:00, IRQ 
10.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link c1e1.
eth1: VIA Rhine III (Management Adapter) at 0xe0040000, 00:0d:b9:14:23:01, IRQ 
12.
eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
br-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
device eth0 entered promiscuous mode
eth0: link up, 100Mbps, full-duplex, lpa 0xC1E1
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state


any idea what is going wrong?


regards

dennis bartsch
freifunk-bno.de



_________________________________________________________________
MSN Video: Coole Beats und krasse Actionen! Kostenlos anschauen!
http://video.msn.com/?mkt=de-de
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
http://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel

Reply via email to