Here's some more info: the diff between dmesgs of release and trunk :
--- release.log 2009-11-21 19:55:12.000000000 +0200 +++ trunk.log 2009-11-21 19:55:15.000000000 +0200 @@ -1,5 +1,5 @@ -Linux version 2.6.25.20 (a...@stable-sandbox) (gcc version 4.1.2) #4 Mon Jun 1 23:39:13 UTC 2009 +Linux version 2.6.30.9 (lindi-bui...@debtree) (gcc version 4.3.3 (GCC) ) #1 Sun Nov 1 19:43:05 UTC 2009 CPU revision is: 00029008 (Broadcom BCM3302) ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x0E, vendor 0x4243) ssb: Core 1 found: Fast Ethernet (cc 0x806, rev 0x09, vendor 0x4243) @@ -9,40 +9,54 @@ ssb: Core 5 found: IEEE 802.11 (cc 0x812, rev 0x09, vendor 0x4243) ssb: Core 6 found: Roboswitch (cc 0x81C, rev 0x02, vendor 0x4243) ssb: Initializing MIPS core... -ssb: set_irq: core 0x0806, irq 2 => 2 -ssb: set_irq: core 0x0817, irq 4 => 3 -ssb: set_irq: core 0x0812, irq 0 => 4 +ssb: core 0x0800, irq : 2(S) 3* 4 5 6 D I +ssb: core 0x0806, irq : 2(S) 3 4* 5 6 D I +ssb: core 0x0816, irq : 2(S) 3 4 5* 6 D I +ssb: core 0x0817, irq : 2(S) 3 4 5 6* D I +ssb: core 0x080f, irq : 2(S) 3 4 5 6 D I* +ssb: core 0x0812, irq : 2(S)* 3 4 5 6 D I +ssb: core 0x081c, irq : 2(S) 3 4 5 6 D I* +ssb: set_irq: core 0x0806, irq 4 => 4 +ssb: set_irq: core 0x0816, irq 5 => 2 +ssb: set_irq: core 0x0812, irq 2 => 5 +ssb: after irq reconfiguration +ssb: core 0x0800, irq : 2(S) 3* 4 5 6 D I +ssb: core 0x0806, irq : 2(S) 3 4* 5 6 D I +ssb: core 0x0816, irq : 2(S)* 3 4 5 6 D I +ssb: core 0x0817, irq : 2(S) 3 4 5 6* D I +ssb: core 0x080f, irq : 2(S) 3 4 5 6 D I* +ssb: core 0x0812, irq : 2(S) 3 4 5* 6 D I +ssb: core 0x081c, irq : 2(S) 3 4 5 6 D I* ssb: Sonics Silicon Backplane found at address 0x18000000 Serial init done. Determined physical RAM map: memory: 01000000 @ 00000000 (usable) -Entering add_active_range(0, 0, 4096) 0 entries of 256 used Initrd not found or empty - disabling initrd Zone PFN ranges: - Normal 0 -> 4096 + Normal 0x00000000 -> 0x00001000 Movable zone start PFN for each node early_node_map[1] active PFN ranges - 0: 0 -> 4096 + 0: 0x00000000 -> 0x00001000 On node 0 totalpages: 4096 +free_area_init_node: node 0, pgdat 8027b770, node_mem_map 802be000 Normal zone: 32 pages used for memmap Normal zone: 0 pages reserved Normal zone: 4064 pages, LIFO batch:0 - Movable zone: 0 pages used for memmap Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064 -Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200 +Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200 Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes. Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes -Synthesized clear page handler (26 instructions). -Synthesized copy page handler (46 instructions). +NR_IRQS:128 PID hash table entries: 64 (order: 6, 256 bytes) console [ttyS0] enabled Dentry cache hash table entries: 2048 (order: 1, 8192 bytes) Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) -Memory: 13580k/16384k available (2073k kernel code, 2804k reserved, 308k data, 128k init, 0k highmem) -Calibrating delay loop... 199.16 BogoMIPS (lpj=398336) +Memory: 13432k/16384k available (2143k kernel code, 2952k reserved, 397k data, 132k init, 0k highmem) +Calibrating delay loop... 199.68 BogoMIPS (lpj=399360) Mount-cache hash table entries: 512 -net_namespace: 540 bytes +net_namespace: 528 bytes NET: Registered protocol family 16 +bio: create slab <bio-0> at 0 Switched to high resolution mode on CPU 0 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) @@ -50,14 +64,16 @@ TCP bind hash table entries: 512 (order: -1, 2048 bytes) TCP: Hash tables configured (established 512 bind 512) TCP reno registered -detected lzma initramfs -initramfs: LZMA lc=1,lp=2,pb=2,origSize=512 -squashfs: version 3.0 (2006/03/15) Phillip Lougher +NET: Registered protocol family 1 +squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. +msgmni has been set to 26 +alg: No test for lzma (lzma-generic) +alg: No test for stdrng (krng) io scheduler noop registered io scheduler deadline registered (default) -Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled +Serial: 8250/16550 driver, 2 ports, IRQ sharing enabled serial8250: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A serial8250: ttyS1 at MMIO 0xb8000400 (irq = 3) is a 16550A serial8250.0: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A @@ -79,48 +95,62 @@ Flash device: 0x400000 at 0x1fc00000 bootloader size: 262144 Updating TRX offsets and length: -old trx = [0x0000001c, 0x0000090c, 0x000bd400], len=0x00221000 crc32=0x1c8bfa28 -new trx = [0x0000001c, 0x0000090c, 0x000bd400], len=0x000bd400 crc32=0xe71f29c3 +old trx = [0x0000001c, 0x00000974, 0x000d2800], len=0x00251000 crc32=0xdf674ce3 +new trx = [0x0000001c, 0x00000974, 0x000d2800], len=0x000d2800 crc32=0x896ce4ef Done Creating 4 MTD partitions on "Physically mapped flash": -0x00000000-0x00040000 : "cfe" -0x00040000-0x003f0000 : "linux" -0x000fd400-0x003f0000 : "rootfs" -mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only +0x000000000000-0x000000040000 : "cfe" +0x000000040000-0x0000003f0000 : "linux" +0x000000112800-0x0000003f0000 : "rootfs" +mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only mtd: partition "rootfs" set to be root filesystem -mtd: partition "rootfs_data" created automatically, ofs=250000, len=1A0000 -0x00250000-0x003f0000 : "rootfs_data" -0x003f0000-0x00400000 : "nvram" -TCP vegas registered -NET: Registered protocol family 1 +mtd: partition "rootfs_data" created automatically, ofs=280000, len=170000 +0x000000280000-0x0000003f0000 : "rootfs_data" +0x0000003f0000-0x000000400000 : "nvram" +BCM47xx Watchdog Timer enabled (30 seconds, nowayout) +TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <gree...@candelatech.com> All bugs added by David S. Miller <da...@redhat.com> -VFS: Mounted root (squashfs filesystem) readonly. -Freeing unused kernel memory: 128k freed +VFS: Mounted root (squashfs filesystem) readonly on device 31:2. +Freeing unused kernel memory: 132k freed Please be patient, while OpenWrt loads ... -Algorithmics/MIPS FPU Emulator v1.5 diag: Detected 'Linksys WRT54G/GS/GL' b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is off for TX and off for RX. -roboswitch: Probing device eth0: found! +roboswitch: Probing device eth0: found a 5325! It's a 5350. b44: eth0: powering down PHY mini_fo: using base directory: / mini_fo: using storage directory: /tmp/root b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is off for TX and off for RX. -br-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. -PPP generic driver version 2.4.2 +cfg80211: Using static regulatory domain info +cfg80211: Regulatory domain: US + (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) + (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm) + (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) + (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) + (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) + (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) + (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm) +cfg80211: Calling CRDA for country: US device eth0.0 entered promiscuous mode device eth0 entered promiscuous mode -br-lan: port 1(eth0.0) entering learning state -br-lan: topology change detected, propagating br-lan: port 1(eth0.0) entering forwarding state +b43-phy0: Broadcom 5352 WLAN found (core revision 9) +phy0: Selected rate control algorithm 'minstrel' +Registered led device: b43-phy0::tx +Registered led device: b43-phy0::rx +Registered led device: b43-phy0::radio +Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ] +Broadcom 43xx-legacy driver loaded [ Features: PLID, Firmware-ID: FW10 ] +PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team -nf_conntrack version 0.5.0 (1024 buckets, 4096 max) +NET: Registered protocol family 24 +nf_conntrack version 0.5.0 (256 buckets, 1024 max) jffs2_scan_eraseblock(): End of filesystem marker found at 0x0 jffs2_build_filesystem(): unlocking the mtd device... done. -jffs2_build_filesystem(): erasing all blocks after the end marker... |/-\|/-\|/-\|/-\|/-\|/-\|/done. +jffs2_build_filesystem(): erasing all blocks after the end marker... done. mini_fo: using base directory: / mini_fo: using storage directory: /jffs r...@openwrt:/# \ No newline at end of file _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
