Not certain which config option for uci-defaults you are referring to, so perhaps I am not using the right one for it not to matter?
Not sure, but looks like network gets established from target/linux/ar71xx/base-files/etc/defconfig/wndr3700/network in the base filesystem (or not? it at least appears to be closer to my running /etc/config/network than most of the other copies of network) and this line is in /etc/uci-defaults/network: [ -e /etc/config/network ] && exit 0 (and that would cause uci-defaults/network not to run) (or is that not what runs at first boot that you were referring to?) so I think that would keep the defaults from loading on first boot? If nothing else, I have a few things to try. Will try the target/linux/ar71xx/base-files/etc/defconfig/wndr3700/network first as I think that sounds most promissing. Might be a few days before I gen a new firmware and test it. The flow of all these files/configurations is a bit hard to follow from build system to running system, etc... At least most of it just works, and adding to it is easy enough... just altering some of the defaults can be a bit hard to follow... ----- Original Message ----- From: "Daniel Dickinson" <dan...@powercloudsystems.com> To: "OpenWrt Development List" <openwrt-devel@lists.openwrt.org> Cc: "Hannu Nyman" <hannu.ny...@iki.fi> Sent: Thursday, November 29, 2012 5:42:10 PM Subject: Re: [OpenWrt-Devel] Change Default IP? Actually shouldn't matter. If using right config option (under Image options IRC) then there will be an uci-defaults file that runs on firstboot to set the ipaddr, which should occur after the defconfig configuration. At least that's the intended design; if the order of scripts is wrong then that's a bug. Regards, Daniel On 29/11/2012 5:21 PM, Hannu Nyman wrote: > You mentioned later in the thread that you are building for wndr3800. > That is the key info here. > > Due to complex switch port LED defintions, WNDR3700/3800 has a > dedicated network file template that will be used: > https://dev.openwrt.org/browser/trunk/target/linux/ar71xx/base-files/etc/defconfig/wndr3700/network > > > It has the section: > config interface lan > option ifname eth0.1 > option type bridge > option proto static > option ipaddr 192.168.1.1 > option netmask 255.255.255.0 > > > On 29.11.2012 1:38, John Lauro wrote: >> Is there a place to change the default IP for a firmware build? >> >> I tried setting under Image configuration -> Preinit configuration >> options -> IP address for preinit network messages, but that doesn't >> seem to work (not that I expected to, but it's the only config >> options I could find related to an IP address). Doing a search of my >> build tree, 192.168.1.1 seems to be embedded in several spots. >> >> > > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/mailman/listinfo/openwrt-devel -- Daniel Dickinson PowerCloud Systems, Palo Alto, CA Senior Firmware Engineer (In Canada: Senior Firmware Analyst) _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
