On Jun 9, 2015 7:36 AM, "Christian Lamparter" <chunk...@googlemail.com> wrote: > > On Wednesday, June 03, 2015 05:20:22 PM Christian Lamparter wrote: > > The mynet range extender hardware is suffering from ethernet > > link loss when booting with a recent openwrt image. This only > > happens on 100mbps links, with 1Gbps speed the link was fine. > > > > The cause of the problem is that the AR8035 PHY (aka F1E) > > requires turning on and off the special TX delay setting > > depending on the speed of the link. > > > > The 10mbps mode only needed the proper pll value, which was > > extracted from the vendor code. > > > > Reported-by: Pascal Paradis > > Signed-off-by: Christian Lamparter <chunk...@googlemail.com> > > No comments so far (but also, no merge). Ping?
Actually, I have one question, most PHY s should disable these kinds of delays when linking at 10/100Mbits/sec. Is not that working here because the registers used have a special behavior (force or override), or is it broken at the hardware level? > > Regards, > Christian > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
