There are some cases where ISPs are running ATM over VDSL or PTM over
ADSL, this is not the common case, but these cases exist. Make it
possible to configure OpenWrt for such cases by adding a new config
option line_mode.

Signed-off-by: Hauke Mehrtens <ha...@hauke-m.de>
---
 .../network/config/ltq-vdsl-app/files/dsl_control    | 20 ++++++++++++++++++--
 1 file changed, 18 insertions(+), 2 deletions(-)

diff --git a/package/network/config/ltq-vdsl-app/files/dsl_control 
b/package/network/config/ltq-vdsl-app/files/dsl_control
index ba77a6f..6997f28 100644
--- a/package/network/config/ltq-vdsl-app/files/dsl_control
+++ b/package/network/config/ltq-vdsl-app/files/dsl_control
@@ -162,6 +162,8 @@ start_service() {
        local tone_adsl
        local tone_vdsl
        local xtse
+       local xfer_mode
+       local line_mode
        local mode
        local lowlevel
 
@@ -170,6 +172,7 @@ start_service() {
        config_get annex dsl annex
        config_get firmware dsl firmware
        config_get xfer_mode dsl xfer_mode
+       config_get line_mode dsl line_mode
 
        eval "xtse=\"\${xtse_xdsl_$annex}\""
 
@@ -179,14 +182,27 @@ start_service() {
        atm)
                LOAD=ltq_atm_vr9
                UNLOAD=ltq_ptm_vr9
+
+               # in most cases atm is used on top of adsl
+               [ -z "${line_mode}" ] && line_mode=adsl
+               ;;
+       *)
+               LOAD=ltq_ptm_vr9
+               UNLOAD=ltq_atm_vr9
+
+               # in most cases ptm is used on top of vdsl
+               [ -z "${line_mode}" ] && line_mode=vdsl
+               ;;
+       esac
+
+       case "${line_mode}" in
+       adsl)
                mode=1
 
                # mask out VDSL bits when ATM is requested
                xtse="${xtse%_*}_00"
                ;;
        *)
-               LOAD=ltq_ptm_vr9
-               UNLOAD=ltq_atm_vr9
                mode=2
                ;;
        esac
-- 
2.7.0
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel

Reply via email to