From: Petr Štetiar <pstet...@ext.nomosphere.fr> CPU: AR9342 SoC RAM: 64 MB DDR2 Flash: 8 MB NOR SPI Ports: 100 MBit (24V PoE in) WLAN: 2.4 GHz UART: 1 UART on PCB marked as J1 with 115200 8N1 config LEDs: Power, Ethernet, WPS, USB, RF 2.4G, RF 5G Buttons: Reset
UART connection details .---------------------------------. | | [ETH] J1 [ANT] | o VCC o RX o TX o GND | `---------------------------------' Flashing instructions A) Serial console, U-Boot and TFTP 1. Connect to serial header J1 on the PCB 2. Power on device and enter U-Boot console 3. Set up TFTP server serving an OpenWrt initramfs build 4. Load initramfs build using the command tftpboot in the U-Boot cli 5. Boot the loaded image using the command bootm 6. Copy squashfs OpenWrt sysupgrade build to the booted device 7. Use mtd to write sysupgrade to partition "firmware" 8. Reboot and enjoy B) Sysupgrade over SSH in airOS v6.1.7 1. Upgrade or downgrade airOS to v6.1.7 2. git clone https://github.com/true-systems/ubnt-bullet-m2hp-openwrt-flashing 3. cd ubnt-bullet-m2hp-openwrt-flashing 4. less README.md 5. make flash FW_UBNT=/path/to/your/openwrt-ath79-generic-ubnt_bullet-m2hp-squashfs-sysupgrade.bin Signed-off-by: Petr Štetiar <yn...@true.cz> --- target/linux/ath79/base-files/etc/board.d/01_leds | 1 + .../linux/ath79/base-files/etc/board.d/02_network | 1 + target/linux/ath79/dts/ar9342_ubnt_bullet-m2hp.dts | 66 ++++++++++++++++ target/linux/ath79/dts/ar9342_ubnt_xw.dtsi | 88 ++++++++++++++++++++++ target/linux/ath79/image/generic-ubnt.mk | 16 ++++ 5 files changed, 172 insertions(+) create mode 100644 target/linux/ath79/dts/ar9342_ubnt_bullet-m2hp.dts create mode 100644 target/linux/ath79/dts/ar9342_ubnt_xw.dtsi diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index f04eb7f..281686e 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -94,6 +94,7 @@ tplink,tl-wr841-v11) ucidef_set_led_switch "lan4" "LAN4" "tp-link:green:lan4" "switch0" "0x02" ;; ubnt,bullet-m|\ +ubnt,bullet-m2hp|\ ubnt,nano-m|\ ubnt,rocket-m) ucidef_set_rssimon "wlan0" "200000" "1" diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 5f02c57..8556bd3 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -22,6 +22,7 @@ ath79_setup_interfaces() tplink,tl-wa901nd-v2|\ tplink,tl-wr703n|\ ubnt,bullet-m|\ + ubnt,bullet-m2hp|\ ubnt,lap-120|\ ubnt,nanostation-ac-loco|\ ubnt,rocket-m|\ diff --git a/target/linux/ath79/dts/ar9342_ubnt_bullet-m2hp.dts b/target/linux/ath79/dts/ar9342_ubnt_bullet-m2hp.dts new file mode 100644 index 0000000..2e978cf --- /dev/null +++ b/target/linux/ath79/dts/ar9342_ubnt_bullet-m2hp.dts @@ -0,0 +1,66 @@ +// SPDX-License-Identifier: GPL-2.0 +/dts-v1/; + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +#include "ar9342_ubnt_xw.dtsi" + +/ { + compatible = "ubnt,bullet-m2hp", "ubnt,xw"; + model = "Ubiquiti Bullet M2HP (XW)"; + + gpio-leds { + compatible = "gpio-leds"; + + link1 { + label = "ubnt:red:link1"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + link2 { + label = "ubnt:orange:link2"; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + }; + + link3 { + label = "ubnt:green:link3"; + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + }; + + link4 { + label = "ubnt:green:link4"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&mdio0 { + status = "okay"; + + phy-mask = <4>; + phy4: ethernet-phy@4 { + phy-mode = "rgmii"; + reg = <4>; + }; +}; + +ð0 { + status = "okay"; + + pll-data = <0x06000000 0x00000101 0x00001313>; + mtd-mac-address = <&eeprom 0x0>; + + phy-mode = "rgmii"; + phy-handle = <&phy4>; + + gmac-config { + device = <&gmac>; + rxd-delay = <3>; + rxdv-delay = <3>; + }; +}; + +ð1 { + status = "disabled"; +}; diff --git a/target/linux/ath79/dts/ar9342_ubnt_xw.dtsi b/target/linux/ath79/dts/ar9342_ubnt_xw.dtsi new file mode 100644 index 0000000..c5ae5df --- /dev/null +++ b/target/linux/ath79/dts/ar9342_ubnt_xw.dtsi @@ -0,0 +1,88 @@ +// SPDX-License-Identifier: GPL-2.0 + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +#include "ar9344.dtsi" + +/ { + compatible = "ubnt,xw", "qca,ar9342"; + model = "Ubiquiti Networks XW board"; + + keys { + compatible = "gpio-keys"; + + reset { + label = "Reset button"; + linux,code = <KEY_RESTART>; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; +}; + +&ref { + clock-frequency = <40000000>; +}; + +&uart { + status = "okay"; +}; + +&gpio { + status = "okay"; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x040000>; + read-only; + }; + + partition@40000 { + label = "u-boot-env"; + reg = <0x040000 0x010000>; + read-only; + }; + + partition@50000 { + label = "firmware"; + reg = <0x050000 0x760000>; + }; + + partition@fb0000 { + label = "cfg"; + reg = <0x7b0000 0x040000>; + read-only; + }; + + eeprom: partition@ff0000 { + label = "EEPROM"; + reg = <0x7f0000 0x010000>; + read-only; + }; + }; + }; +}; + +&wmac { + status = "okay"; + + qca,disable-5ghz; + mtd-cal-data = <&eeprom 0x1000>; + mtd-mac-address = <&eeprom 0x1002>; +}; diff --git a/target/linux/ath79/image/generic-ubnt.mk b/target/linux/ath79/image/generic-ubnt.mk index bb86c8b..d12a32e 100644 --- a/target/linux/ath79/image/generic-ubnt.mk +++ b/target/linux/ath79/image/generic-ubnt.mk @@ -63,6 +63,15 @@ define Device/ubnt-wa ATH_SOC := ar9342 endef +define Device/ubnt-xw + $(Device/ubnt) + UBNT_TYPE := XW + UBNT_CHIP := ar934x + UBNT_BOARD := XM + UBNT_VERSION := 6.0.4 + ATH_SOC := ar9342 +endef + define Device/ubnt_bullet-m $(Device/ubnt-xm) DEVICE_TITLE := Ubiquiti Bullet-M @@ -70,6 +79,13 @@ define Device/ubnt_bullet-m endef TARGET_DEVICES += ubnt_bullet-m +define Device/ubnt_bullet-m2hp + $(Device/ubnt-xw) + DEVICE_TITLE := Ubiquiti Bullet M2HP + SUPPORTED_DEVICES += bullet-m2hp +endef +TARGET_DEVICES += ubnt_bullet-m2hp + define Device/ubnt_rocket-m $(Device/ubnt-xm) DEVICE_TITLE := Ubiquiti Rocket-M -- 1.9.1 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
