There is no need to define a static link or a phy for the sfp
ports. Using phy-mode and managed properties to describe the
link to the sfp phy.
We have to keep the now unconnected virtual "phys" because the
switch driver uses their "phy-is-integrated" property to figure
out which ports to enable as fibre ports.
Acked-by: Birger Koblitz <m...@birger-koblitz.de>
Signed-off-by: Bjørn Mork <bj...@mork.no>
---
.../realtek/dts/rtl8380_zyxel_gs1900-10hp.dts | 24 +++++--------------
1 file changed, 6 insertions(+), 18 deletions(-)
diff --git a/target/linux/realtek/dts/rtl8380_zyxel_gs1900-10hp.dts
b/target/linux/realtek/dts/rtl8380_zyxel_gs1900-10hp.dts
index 92d0e25fc477..c16028788ea4 100644
--- a/target/linux/realtek/dts/rtl8380_zyxel_gs1900-10hp.dts
+++ b/target/linux/realtek/dts/rtl8380_zyxel_gs1900-10hp.dts
@@ -17,7 +17,7 @@
};
sfp0: sfp-p9 {
- compatible = "_sff,sfp";
+ compatible = "sff,sfp";
i2c-bus = <&i2c0>;
los-gpio = <&gpio1 27 GPIO_ACTIVE_HIGH>;
tx-fault-gpio = <&gpio1 22 GPIO_ACTIVE_HIGH>;
@@ -36,7 +36,7 @@
};
sfp1: sfp-p10 {
- compatible = "_sff,sfp";
+ compatible = "sff,sfp";
i2c-bus = <&i2c1>;
los-gpio = <&gpio1 33 GPIO_ACTIVE_HIGH>;
tx-fault-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
@@ -55,29 +55,17 @@
port@24 {
reg = <24>;
label = "lan9";
- phy-mode = "rgmii-id";
- phy-handle = <&phy24>;
+ phy-mode = "1000base-x";
+ managed = "in-band-status";
sfp = <&sfp0>;
-
- fixed-link {
- speed = <1000>;
- full-duplex;
- pause;
- };
};
port@26 {
reg = <26>;
label = "lan10";
- phy-mode = "rgmii-id";
- phy-handle = <&phy26>;
+ phy-mode = "1000base-x";
+ managed = "in-band-status";
sfp = <&sfp1>;
-
- fixed-link {
- speed = <1000>;
- full-duplex;
- pause;
- };
};
};
};
--
2.20.1
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
