Hey Mika,
On 19/03/2021 11:12, Mika Laitio wrote:
I'm trying to add support for an older ZWave bridge, the MiCasaVerde
Vera Lite (similar or equal to SERCOMM NA300). It's based on RT3662,
64MB RAM and 32MB NAND flash - and this is where I'm currently stuck.
The rt3883.dtsi does not define a NAND controller and I'm unsure
whether there actually is a suitable driver.
Hi little of topic but are there some z-wave bridges that are already
supported by the openwrt? And if you boot openwrt to vera lite via
USB, are you able to see/use the z-wave controller from that device?
I can give you a partial answer: I'm also working on the SERCOMM NA502
and NA502s that are also sold as Vera Secure, Smart Home by Hornbach, A1
Smart Home Gateway and a few other brands (I have the A1 branded
version). Basically, I've got ZWave running, you can track the status
here: https://forum.openwrt.org/t/adding-support-for-sercomms-na502/22495
Regarding the Vera Lite, I'm still investigating the possibilities and
have not yet booted any custom firmware. I don't see a reason why the
ZWave controller shouldn't be visible (it's attached to a UART).
However, I found only limited information in whether this particular
controller is supported by OpenZWave or Z-Wave JS.
My ultimate goal with both SERCOMM devices is getting ZWaveJS2MQTT
running so that a home automation software can talk to the gateway.
Andreas
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
