From: Thomas Aldrian <dev.aldr...@gmail.com> This commit adds support for the Wavlink WL-WN578A2 dual-band wall-plug wireless router. This device is also sold under the name SilverCrest SWV 733 A2.
Device Specifications: - CPU: MediaTek MT7628AN (580MHz) - Flash: 8MB - RAM: 64MB - Bootloader: U-Boot - Ethernet: 2x 10/100 Mbps - 2.4 GHz: 802.11b/g/n SoC - 5 GHz: 802.11a/n/ac MT7610E - Antennas: internal - 4 green LEDs: WPS/Power, LAN, WAN, wifi-low, wifi-med, wifi-high - Buttons: Reset, WPS - Sliding mode switch: AP, repeater, client - Small sliding power switch Flashing instructions: U-Boot launches TFTP client if WPS button is pressed during power-on. Configure as follows: - Server IP: 192.168.10.100 - Filename (rename sysupgrade file to this): firmware.bin Flashing should not take more than a minute, device will reboot automatically. Signed-off-by: Thomas Aldrian <dev.aldr...@gmail.com> --- .../dts/mt7628an_wavlink_wl-wn578a2.dts | 166 ++++++++++++++++++ target/linux/ramips/image/mt76x8.mk | 10 ++ .../mt76x8/base-files/etc/board.d/01_leds | 3 +- .../mt76x8/base-files/etc/board.d/02_network | 6 +- 4 files changed, 182 insertions(+), 3 deletions(-) create mode 100644 target/linux/ramips/dts/mt7628an_wavlink_wl-wn578a2.dts diff --git a/target/linux/ramips/dts/mt7628an_wavlink_wl-wn578a2.dts b/target/linux/ramips/dts/mt7628an_wavlink_wl-wn578a2.dts new file mode 100644 index 0000000000..d7238e17c6 --- /dev/null +++ b/target/linux/ramips/dts/mt7628an_wavlink_wl-wn578a2.dts @@ -0,0 +1,166 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "mt7628an.dtsi" + +#include <dt-bindings/input/input.h> +#include <dt-bindings/gpio/gpio.h> + +/ { + compatible = "wavlink,wl-wn578a2", "mediatek,mt7628an-soc"; + model = "Wavlink WL-WN578A2"; + + aliases { + led-boot = &led_wps; + led-failsafe = &led_wps; + led-running = &led_wps; + led-upgrade = &led_wps; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + gpios = <&gpio 43 GPIO_ACTIVE_LOW>; + linux,code = <KEY_RESTART>; + }; + + wps { + label = "wps"; + gpios = <&gpio 38 GPIO_ACTIVE_LOW>; + linux,code = <KEY_WPS_BUTTON>; + }; + + ap { + label = "ap"; + gpios = <&gpio 41 GPIO_ACTIVE_LOW>; + linux,code = <BTN_0>; + linux,input-type = <EV_SW>; + }; + + repeater { + label = "repeater"; + gpios = <&gpio 42 GPIO_ACTIVE_LOW>; + linux,code = <BTN_1>; + linux,input-type = <EV_SW>; + }; + }; + + leds { + compatible = "gpio-leds"; + + wifi-high { + label = "green:wifi-high"; + gpios = <&gpio 37 GPIO_ACTIVE_LOW>; + }; + + wifi-med { + label = "green:wifi-med"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + wifi-low { + label = "green:wifi-low"; + gpios = <&gpio 44 GPIO_ACTIVE_LOW>; + }; + + lan { + label = "green:lan"; + gpios = <&gpio 40 GPIO_ACTIVE_LOW>; + }; + + wan { + label = "green:wan"; + gpios = <&gpio 39 GPIO_ACTIVE_LOW>; + }; + + led_wps: wps { + label = "green:wps"; + gpios = <&gpio 4 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&state_default { + gpio { + groups = "i2c", "wdt", "wled_an", "p0led_an", "p1led_an", + "p2led_an", "p3led_an", "p4led_an", "refclk", "gpio"; + function = "gpio"; + }; +}; + +&pcie { + status = "okay"; +}; + +&pcie0 { + wifi@0,0 { + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&factory 0x8000>; + ieee80211-freq-limit = <5000000 6000000>; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <40000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x30000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x30000 0x10000>; + read-only; + }; + + factory: partition@40000 { + label = "factory"; + reg = <0x40000 0x10000>; + read-only; + }; + + partition@50000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x50000 0x7b0000>; + }; + }; + }; +}; + +&wmac { + status = "okay"; +}; + +ðernet { + mtd-mac-address = <&factory 0x28>; +}; + +&esw { + mediatek,portmap = <0x2f>; +}; + +&usbphy { + status = "disabled"; +}; + +&ehci { + status = "disabled"; +}; + +&ohci { + status = "disabled"; +}; diff --git a/target/linux/ramips/image/mt76x8.mk b/target/linux/ramips/image/mt76x8.mk index d5a9684dba..c4f27357a3 100644 --- a/target/linux/ramips/image/mt76x8.mk +++ b/target/linux/ramips/image/mt76x8.mk @@ -733,6 +733,16 @@ define Device/wavlink_wl-wn577a2 endef TARGET_DEVICES += wavlink_wl-wn577a2 +define Device/wavlink_wl-wn578a2 + IMAGE_SIZE := 7872k + DEVICE_VENDOR := Wavlink + DEVICE_MODEL := WL-WN578A2 + DEVICE_ALT0_VENDOR := SilverCrest + DEVICE_ALT0_MODEL := SWV 733 A2 + DEVICE_PACKAGES := kmod-mt76x0e +endef +TARGET_DEVICES += wavlink_wl-wn578a2 + define Device/widora_neo-16m IMAGE_SIZE := 16064k DEVICE_VENDOR := Widora diff --git a/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds b/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds index fdef158ea8..e2fb44c81e 100644 --- a/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds @@ -129,7 +129,8 @@ wavlink,wl-wn575a3) ucidef_set_led_rssi "wifi-med" "wifi-med" "green:wifi-med" "wlan1" "50" "84" ucidef_set_led_rssi "wifi-high" "wifi-high" "green:wifi-high" "wlan1" "85" "100" ;; -wavlink,wl-wn577a2) +wavlink,wl-wn577a2|\ +wavlink,wl-wn578a2) ucidef_set_led_switch "lan" "lan" "green:lan" "switch0" "0x8" ucidef_set_led_switch "wan" "wan" "green:wan" "switch0" "0x10" ;; diff --git a/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network b/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network index 5ce44d0e9b..d61a60591c 100644 --- a/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network +++ b/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network @@ -46,7 +46,8 @@ ramips_setup_interfaces() ;; buffalo,wcr-1166ds|\ elecom,wrc-1167fs|\ - wavlink,wl-wn577a2) + wavlink,wl-wn577a2|\ + wavlink,wl-wn578a2) ucidef_add_switch "switch0" \ "3:lan" "4:wan" "6@eth0" ;; @@ -168,7 +169,8 @@ ramips_setup_macs() ;; cudy,wr1000|\ hilink,hlk-7688a|\ - wavlink,wl-wn577a2) + wavlink,wl-wn577a2|\ + wavlink,wl-wn578a2) wan_mac=$(mtd_get_mac_binary factory 0x2e) label_mac=$(mtd_get_mac_binary factory 0x4) ;; -- 2.31.1 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel