The sender domain has a DMARC Reject/Quarantine policy which disallows sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped automatically by the mailing list software.
--- Begin Message ---Hi On 2025-01-02, Linus Walleij wrote: > We can use a package for the MV88E6060 DSA switch on the single > ath79 device that uses it, saving around 600 KB of memory on > all other devices (for the DSA infrastructure, mainly). > > As far as I can see the TP-Link TL WR941 v2 is the only device > using MV88E6060 and the only device with a DSA switch overall. > > However the ath79 people should look at this so I'm not > mistaken. At this point, tl-wr941nd v2/ v3 support can probably just as well be dropped. It's a 4/32 device, it's impossible (at least not reasonable) to fit OpenWrt into its 4 MB (minus 192 KB for u-boot and ART) flash anymore. I tried last February and disposed my tl-wr941nd v3 afterwards (so I can no longer test it), as it was no longer reasonably feasible. https://forum.openwrt.org/t/cant-connect-to-router-page/187095/17 At least the effort to (re-)add those three config symbols would be much easier than shaving off another 800 KB (or ~950-1000 KB with kernel v6.6 now) from that already below-minimal image. Regards Stefan Lippers-Hollmann
--- End Message ---
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
