The sender domain has a DMARC Reject/Quarantine policy which disallows sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped automatically by the mailing list software.
--- Begin Message ---From: Ivan Davydov <[email protected]> Disassembly: At the bottom there are 4 screws hidden by rubber feet. After removing the screws, pry the gray plastic part around (it is secured with latches) and remove it. Serial Interface: The serial interface can be connected to the 4 pin dots to the left of the flash. Pins (from LEDs to LAN ports): 3.3V (do not connect) | TX | RX | GND Settings: 57600, 8N1 Flashing via TFTP: 1. Connect your PC and router to port 1-3, configure PC interface using IP 192.168.1.2, mask 255.255.255.252 2. Serve the firmware image (for OpenWRT it is *-squashfs-factory.bin) renamed to KN-1510_recovery.bin via TFTP 3. Power up the router while pressing Reset button on the back (ex. with a toothstick) 4. Release Restart button when the Power LED starts blinking To revert back to OEM firmware: The return to the OEM firmware is carried out by using the methods described above with the help of the appropriate firmware image. When using OEM bootloader, the firmware image size cannot exceed the size of one OEM "Firmware_x" partition or Kernel + rootFS size. Signed-off-by: Ivan Davydov <[email protected]> --- .../ramips/dts/mt7628an_keenetic_kn-1510.dts | 236 ++++++++++++++++++ target/linux/ramips/image/mt76x8.mk | 11 + .../mt76x8/base-files/etc/board.d/01_leds | 1 + .../mt76x8/base-files/etc/board.d/02_network | 2 + 4 files changed, 250 insertions(+) create mode 100644 target/linux/ramips/dts/mt7628an_keenetic_kn-1510.dts diff --git a/target/linux/ramips/dts/mt7628an_keenetic_kn-1510.dts b/target/linux/ramips/dts/mt7628an_keenetic_kn-1510.dts new file mode 100644 index 0000000000..62d46066f9 --- /dev/null +++ b/target/linux/ramips/dts/mt7628an_keenetic_kn-1510.dts @@ -0,0 +1,236 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "mt7628an.dtsi" + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> +#include <dt-bindings/leds/common.h> + +/ { + compatible = "keenetic,kn-1510", "mediatek,mt7628an-soc"; + model = "Keenetic KN-1510"; + + aliases { + label-mac-device = ðernet; + + led-boot = &led_power; + led-failsafe = &led_power; + led-running = &led_power; + led-upgrade = &led_power; + }; + + chosen { + bootargs = "console=ttyS0,57600"; + }; + + leds { + compatible = "gpio-leds"; + + led_power: power { + function = LED_FUNCTION_POWER; + color = <LED_COLOR_ID_GREEN>; + gpios = <&gpio 44 GPIO_ACTIVE_LOW>; + }; + + internet { + function = LED_FUNCTION_WAN; + color = <LED_COLOR_ID_GREEN>; + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; + }; + + wifi2 { + function = LED_FUNCTION_WLAN_2GHZ; + color = <LED_COLOR_ID_GREEN>; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; + }; + + wifi5 { + function = LED_FUNCTION_WLAN_5GHZ; + color = <LED_COLOR_ID_GREEN>; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy1tpt"; + }; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + gpios = <&gpio 38 GPIO_ACTIVE_LOW>; + linux,code = <KEY_RESTART>; + }; + + wps { + label = "wps"; + gpios = <&gpio 37 GPIO_ACTIVE_LOW>; + linux,code = <KEY_WPS_BUTTON>; + }; + }; + + virtual_flash { + compatible = "mtd-concat"; + devices = <&firmware1 &firmware2>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x0 0x1000000>; + }; + }; + }; +}; + +&state_default { + gpio { + groups = "i2s", "gpio", "refclk", "wdt", "wled_an"; + function = "gpio"; + }; +}; + +&usbphy { + status = "disabled"; +}; + +&ehci { + status = "disabled"; +}; + +&ohci { + status = "disabled"; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <32000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x30000>; + read-only; + }; + + partition@30000 { + label = "u-config"; + reg = <0x30000 0x10000>; + read-only; + }; + + partition@40000 { + label = "rf-eeprom"; + reg = <0x40000 0x10000>; + read-only; + + nvmem-layout { + compatible = "fixed-layout"; + #address-cells = <1>; + #size-cells = <1>; + + eeprom_factory_0: eeprom@0 { + reg = <0x0 0x400>; + }; + + eeprom_factory_8000: eeprom@8000 { + reg = <0x8000 0x200>; + }; + + macaddr_factory_4: macaddr@4 { + reg = <0x4 0x6>; + }; + }; + }; + + firmware1: partition@50000 { + label = "firmware_1"; + reg = <0x50000 0x790000>; + }; + + partition@7e0000 { + label = "config_1"; + reg = <0x7e0000 0x10000>; + read-only; + }; + + partition@7f0000 { + label = "dump"; + reg = <0x7f0000 0x10000>; + read-only; + }; + + partition@800000 { + label = "u-state"; + reg = <0x800000 0x30000>; + read-only; + }; + + partition@830000 { + label = "u-config_res"; + reg = <0x830000 0x10000>; + read-only; + }; + + partition@840000 { + label = "rf-eeprom_res"; + reg = <0x840000 0x10000>; + read-only; + }; + + firmware2: partition@850000 { + label = "firmware_2"; + reg = <0x850000 0x790000>; + }; + + partition@fe0000 { + label = "config_2"; + reg = <0xfe0000 0x10000>; + read-only; + }; + }; + }; +}; + +ðernet { + nvmem-cells = <&macaddr_factory_4>; + nvmem-cell-names = "mac-address"; +}; + +&esw { + mediatek,portmap = <0x3e>; + mediatek,portdisable = <0x30>; +}; + +&wmac { + status = "okay"; + + nvmem-cells = <&eeprom_factory_0>; + nvmem-cell-names = "eeprom"; +}; + +&pcie { + status = "okay"; +}; + +&pcie0 { + wifi@0,0 { + compatible = "mediatek,mt76"; + reg = <0x0000 0 0 0 0>; + nvmem-cells = <&eeprom_factory_8000>; + nvmem-cell-names = "eeprom"; + ieee80211-freq-limit = <5000000 6000000>; + }; +}; diff --git a/target/linux/ramips/image/mt76x8.mk b/target/linux/ramips/image/mt76x8.mk index 2555596edf..acab39a57c 100644 --- a/target/linux/ramips/image/mt76x8.mk +++ b/target/linux/ramips/image/mt76x8.mk @@ -442,6 +442,17 @@ define Device/keenetic_kn-1221 endef TARGET_DEVICES += keenetic_kn-1221 +define Device/keenetic_kn-1510 + IMAGE_SIZE := 16064k + DEVICE_VENDOR := Keenetic + DEVICE_MODEL := KN-1510 + DEVICE_PACKAGES := kmod-mt76x0e + IMAGES += factory.bin + IMAGE/factory.bin := $$(sysupgrade_bin) | pad-to $$$$(BLOCKSIZE) | \ + check-size | zyimage -d 0x801510 -v "KN-1510" +endef +TARGET_DEVICES += keenetic_kn-1510 + define Device/keenetic_kn-1613 IMAGE_SIZE := 15073280 DEVICE_VENDOR := Keenetic diff --git a/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds b/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds index 5f74acf45f..31fdc3b9e7 100644 --- a/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds @@ -64,6 +64,7 @@ hiwifi,hc5761a) keenetic,kn-1112|\ keenetic,kn-1212|\ keenetic,kn-1221|\ +keenetic,kn-1510|\ keenetic,kn-1613|\ keenetic,kn-1711|\ keenetic,kn-1713) diff --git a/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network b/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network index d1689ccc2f..e949d731c2 100644 --- a/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network +++ b/target/linux/ramips/mt76x8/base-files/etc/board.d/02_network @@ -142,6 +142,7 @@ ramips_setup_interfaces() ;; keenetic,kn-1112|\ keenetic,kn-1212|\ + keenetic,kn-1510|\ keenetic,kn-1613|\ keenetic,kn-1713|\ motorola,mwr03) @@ -311,6 +312,7 @@ ramips_setup_macs() wan_mac=$(mtd_get_mac_binary factory 0x2e) ;; keenetic,kn-1221|\ + keenetic,kn-1510|\ keenetic,kn-1613|\ keenetic,kn-3211|\ zyxel,keenetic-extra-ii) -- 2.47.3
--- End Message ---
_______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
