#18152: Asus RT-N18U can see only 128 meg RAM (specs say 256 on board)
--------------------------+----------------------------------
Reporter: Grrruk | Owner: developers
Type: defect | Status: new
Priority: normal | Milestone: Chaos Calmer (trunk)
Component: base system | Version: Trunk
Resolution: | Keywords: RT-N18U
--------------------------+----------------------------------
Comment (by Grrruk):
Well, I loaded nightly build and alas, it does not go into failsafe to.
Power button is lit and then system boots normally. I can get into
failsafe via serial console, but pressing wps or reset does nothing,
nothing changes on console output and nothing happens in logs. Just re-
checked buttons, Reset button is still GPIO7, WPS is still GPIO11,
pressing the button results in 1 going to 0, i.e. active low... For
example:
Initial state:
root@OpenWrt:/tmp# ./button.sh | grep GPIO7
[GPIO7] value 1
After pressing Reset:
root@OpenWrt:/tmp# ./button.sh | grep GPIO7
[GPIO7] value 0
After releasing Reset:
root@OpenWrt:/tmp# ./button.sh | grep GPIO7
[GPIO7] value 1
BTW, power button does not behave like it did on N16. On N16 it blinked
slow during initial stages of flash setup, but here power button is lit at
powerup and then nothing changes.
Network is still faulty, it works about 5 times out of 10 reboots.
Sometimes it works, sometimes does not. It does not matter how I reboot --
using reboot command, removing power cord or pushing power button,
sometimes it does not work several times in row then it works again, etc.
I suspected faulty cable, but it happens with new good ethernet cable too.
And nothing like that with shibby or stock firmware.
--
Ticket URL: <https://dev.openwrt.org/ticket/18152#comment:11>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
