#20631: Pendriv in USB3.0 is not detected on start WRT1200AC
--------------------+----------------------------------
Reporter: tytan | Owner: developers
Type: defect | Status: new
Priority: normal | Milestone: Chaos Calmer (trunk)
Component: kernel | Version: Trunk
Keywords: |
--------------------+----------------------------------
Applies port USB3. Port USB2.0 working ok.
Device USB key Kingston DTR30G2 (Bus 003 Device 003: ID 0951:16a2
Kingston Technology) in USB3.0 is not detected on start router.
After start is clear in dmesg - no information about device in USB3.0 port
and no device type /dev/sda1.
If I put the usb key to the port USB3.0 after start all it's ok.:
{{{
3239.624028] scsi host2: usb-storage 3-1:1.0
[ 3240.680637] scsi 2:0:0:0: Direct-Access Kingston DTR30G2
PMAP PQ: 0 ANSI: 6
[ 3240.984222] sd 2:0:0:0: [sda] 61472768 512-byte logical blocks: (31.4
GB/29.3 GiB)
[ 3240.992832] sd 2:0:0:0: [sda] Write Protect is off
[ 3240.997669] sd 2:0:0:0: [sda] Mode Sense: 23 00 00 00
[ 3241.003729] sd 2:0:0:0: [sda] No Caching mode page found
[ 3241.009098] sd 2:0:0:0: [sda] Assuming drive cache: write through
[ 3241.045391] sda: sda1
[ 3241.050523] sd 2:0:0:0: [sda] Attached SCSI removable disk
[ 3241.655459] EXT4-fs (sda1): mounted filesystem with ordered data mode.
Opts:
}}}
This is probably problem with some keys. But when I put in USB3.0
different type key Kingston DT microDuo (Bus 003 Device 002: ID 0951:16a3
Kingston Technology) 3.0 system at start detects him ok.
--
Ticket URL: <https://dev.openwrt.org/ticket/20631>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
