#21892: Oxnas pincontrol (GPIO) does not work
------------------------+-----------------------------------------
Reporter: anonymous | Owner: developers
Type: defect | Status: new
Priority: normal | Milestone:
Component: kernel | Version: Trunk
Resolution: | Keywords: oxnas ox820 gpio pincontrol
------------------------+-----------------------------------------
Comment (by anonymous):
> Are the LEDs and buttons actually the same or did you just leave it
there
> hoping that it doesn't hurt to switch pins 5, 6, 10 and 11 of bank A to
be inputs...
Buttons are same, LEDs not, but I left them there expecting they do no
harm. I don't need them, but maybe it's better to remove them from DTS.
I just dont figure out what to try with RTC since it doesn't seem to use
any separate GPIO, IRQ other settin to change. Address @68 is definitely
OK. If I make a separate notch, what should I try to change there?
--
Ticket URL: <https://dev.openwrt.org/ticket/21892#comment:17>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
