On Sep 27, 2014 11:44 PM, "Justin Vallon" <[email protected]> wrote <snip> Adding a route to just the Comcast router is simpler configuration wise, and sufficient for low traffic clients. However, that means the Comcast router will "handle" all traffic bound for the internal subnet. Therefore, if any of the external subnet clients are high traffic, you should manually add a route to those clients as well. > > If you can configure your comcast router, look for something like static > route, add network=192.168.2.0/255.255.255.0 gateway=10.0.0.6. This > will cause the router to forward packets for 192.168.2.0/24 to > 10.0.0.6. You don't have to touch the hosts. > > > > On 9/27/14 10:38 PM, Harry Putnam wrote: > > Sorry if this is a bit too unrelated.. Hoping it is related enough. > > > > I want to attach a second router to my ISP's (comcast) Modem/router (An > > Arris Mod: TG862G/GT). > > > > It has four ports. I want to hook a second router into one of those > > client ports and create a different subnet. > > > > That last referenced router is a TP-link WR1043 that I installed > > openwrt on quite some time ago. But then let it set for mnths and > > mnths. > > > > I'm pretty green with Openwrt, plus have not run it for many months. > > > > So, cutting to the chase. The router is set up now and is routing for > > a wireless subnet in my downstairs rooms. > > > > At present on the lower subnet (diagrammed below) hosts can `see' > > there own subnet plus any hosts on the upper subnet. > > > > However hosts on the upper subnet cannot `see' hosts on the lower > > subnet. > > > > ------- ------- ---=--- ------- ------- > > > > The ISP modem/router lan interface: 10.0.0.1 - wan interface xxx.xxx.xxx.xxx > > > > The TP-link lan interface: 192.168.2.1 - wan interface 10.0.0.6 > > > > (Rough Diagram): > > > > > > internet > > | > > X IP xxx.xxx.xxx.xxx > > Comcast modem/router > > | X | lan 10.0.0.1 (upper subnet) > > | h1 | | h2 > > | > > X wan 10.0.0.6 > > Openwrt router > > X X lan 192.168.2.1 (Lower subnet) > > | | > > | h3 | h4 > > > > I can connect to the owrt config gui from the `lower' subnet but, > > I'm unable to get to owrt gui from `upper' subnet > > (outer facing) interface. > > > > Is this a case that needs port forwarding? or what? > > > > I'd like to be able to get to the gui config if possible from upper > > subnet. > > _______________________________________________ > > openwrt-users mailing list > > [email protected] > > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users > > > -- > -Justin > [email protected] > > > > _______________________________________________ > openwrt-users mailing list > [email protected] > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users >
_______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
