On Wed, Oct 14, 2015 at 07:58:20AM +0100, Simon Iremonger (wiltslug) wrote: > p.s. Do note that the 'ndisc6' package includes a 'rdisc6' > tool... 'rdisc6 eth1' (replace eth1 with WAN interface) > may give clues. >
Hi Christian and Simon, Thanks for your replies! Getting a prefix configured on the LAN port would be great :) @Simon: the tools you mentioned I don't find in the CC repos. > I suspect that one of:- > > a) > You have older OpenWRT that doesn't deal with DHCPv6 / IPv6 > prefix delegation // passthrough automatically without more > manua configuration of radvd for prefixes on lan and so on! I've got CC. My expectation was (and still is) that IPv6 will just work on CC. Actually I don't think that the router is at fault. > b) > OpenWRT is ONLY getting an RA but never getting a DHCPv6-PD > (prefix delegation) to setup a subnet on the secondary side > of the router (br-lan). > Either they haven't done DHCPv6 that yet or they expect you > to use 'bridged mode' (sharing the same /64 on both sides) > instead of DHCPv6-PD. That seems to be the issue. If I interpret this correctly then odhcp6c tries to solicit a prefix from the ISP for the LAN interface. But there's never any reply. At this point I think that my connection really doesn't support IPv6 yet. I'll probably talk to the ISP at some point in the future about this. Again, thanks for your replies! Regards, Sebastian _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
