On 2009-05-13 12:41, Ton Voon wrote: > Passive service checks usually require you to manually change the > state back.
Fair enough, that makes sense. Could you advise on how this is done ? Would be great if you can use the GUI to change a critical state to an OK state. But I cannot see any way to do this. > However... I've just thought that we could have a servicecheck with a > flag which is "reset state to OK after failure". So when an alert > comes in, it goes through the state change including notifications and > then we set a new state to change it back to OK automatically. This > means the notification becomes the main method of finding out about > these type of errors as the status view will show OK most of the time. > > This would require a change in the service checks page, a change in > the configuration of the service to set this flag and a Nagios broker > module to take affect if this flag is set on a service. Sounds like a lot of work which would require a sponsor I guess ? I genuinely wish we were in a position to provide this sponsorship but sadly it's just not the case right now. I sincerely hope this changes in the future. For now I'd be happy to be able to manually change critical states to OK states via the GUI once we're happy the problem is resolved. Is this possible ? _______________________________________________ Opsview-users mailing list [email protected] http://lists.opsview.org/listinfo/opsview-users
